开云体育

Vic just posted this in another group. If anyone takes him up on his offer I would be interested in any accessories for the PTR4400/RT-F200 that they don't want. Howard VK4BS Guys, I have around 30

Vic just posted this in another group. If anyone takes him up on his offer I would be interested in any accessories for the PTR4400/RT-F200 that they don't want. Howard VK4BS Guys, I have around 30

We have 4 unit full ser Racal PRM-4021, but we have problem with TX. Please find the attachement. ? ? Aris YC1RSC

Patricio Diez Butty wrote: 3 cells Patricio, so 3.6 Volts nominally. I made replacements from 3 x 100 mAH NiMH button cells potted in epoxy similar to the originals. I even copied the original label.

Thank you Dan for the battery cell info. I take it away from the unit. Wich voltage does it have? Best regards, Patricio Lic. Patricio Diez Butty --- El lun 2-ago-10, Dan Rae <danrae@...>

Thank you again Dan. Yes I see the cell you mean now. I will change it. I search the net but I couldn't find the manual for this unit. Best regards, Patricio Lic. Patricio Diez Butty --- El lun

Dan That was very much what a contact I have who used to work for Racal rather thought of thir technical expertise. They were said to have purchased channelled radios so they did not know what

Hi to all! I have a good looking ,fully functional PRM-4021 2-16 MhZ MANPACK. for all details please contact off list 4z4rb@... thank you. Baruch 4z4rb

Patricio Diez Butty wrote: It has a Nicad battery to back up the settings. It is an epoxy encapsulated thing, yellow with white printed label, about 3 x 5 cm, visible on one of the boards when you

Andy Jackson G8JAC wrote: Andy, I've no idea. Just because you are paranoid doesn't mean they aren't listening :^) However I would think that a frequency hopping radio is slightly easier to crack than

Thank you Dan for your information. "make sure the Nicad battery has not leaked and damaged the circuit board." Sorry I don't follow. This unit have a batery inside? My Thomson TRC 310 have two pins

Dan wrote: ..>It is an interestingly designed unit; despite the millions of possible ..>settings of the internal links etc., a unit I have that had been used by ..>the Iraqi army Republican Guard had

p10butty wrote: If the audio levels are similar to those from a Racal radio, then yes. Yes. Where else could it come from? But you are going to need two ( or more ) of course. You can check pairs of

Hello guys, I get an almost new Racal MA 4224 encryption unit. They seem that our Army bought them before 1982. They are new. I think they don't used them. My question should be: Would I be able to

These have 7-pin Amphenol conectors, but the keying is NOT the same as the PRM 4090. The 6-pin Syncal 30 handsets fit the 7-pin connectors on the PRM 4090 but the Clansman connectors will not. Is that

I have three extra handsets, 5965-99-620-5669, in Virginia, USA. They have the Clansman connector (not the later one for the Syncal 30) and are unused and look almost new. Make an offer. --scott

I have one of these, NSN 5810-99-895-7927, which has a 7 pin female connection for the Clansman harness and a 7 pin male connection for the Cougar set. I would ideally like the circuit for it but

Scott When you say Not the later ones for the Syncal 30, they are in fact the earlier ones, the Syncal 30 has 6 pin Amphenol connector, and the Later Clansman range has 7 pins, also amphenol. Stuart

Patricio I haven't seen a PRM-4031 for sale recently. I suspect you will have to wait until one comes up on E-Bay or one of the yahoo groups. Regarding your question on the 7-pin plugs you really need