开云体育

Steve, I’m attaching my P900 quads that work well for these two papers. Try them and see if they work for you, but at the very least they will be a good starting point to print and run through QCDN

Double-click on the erroneous measurement in the lefthand table and manually type in a new value to straighten out the curve. Hope that helps, Richard

Greetings, Anyone have a suggestion on how to correct the blips seen in the photos of higher values for both Ilford Warm Tone, and Ilford Classic silver gelatin multi-contrast papers ?? Repeated

I’ll answer this as I am the creator of the installer you are referencing. Jon is referencing a Mac workflow (installer script) so may have no realized you were on the PC. I hadn’t realized that

That's where I'm installing P2 curves from -- Piezography Community Edition -- but they're not showing up in the curves drop down menu when I run QTR.

Jon, The command script in the folder I maintain my P2 curves?? I am using the "Install Piezography HD P2 Curves" from the Piezography Community Editions folder.? I didn't create the curves, they

Bill, As I instructed you earlier, you need to run the command script in the folder where you maintain your P2 curves that have the unused PiezoFlush filled channels. Running that install script will

P2 curves are found here: https://piezography.com/downloads/piezography-community-edition best -W

P2 curves are from the piezo products. They are not included with QTR. So get them from piezo and install using their instructions. [email protected]> wrote:

This was corrected but now the problem is that I can't load the P2 curves.? It's showing an abbreviated list that is a different set of curves that print incorrectly, using channels that contain

I'm at a loss. ?I've been printing for several years without issue using QuadTone RIP and Inkjet Mall Piezography inks on an Epson 3800. ?Now the printer will load the paper & begin printing, but

I'll definitely take a look at the QCDN handout. Thanks for sending it along! I've been watching Bill Schwab’s videos on YouTube... they've been very helpful. So glad to hear I'm not the only one

Here is a handout that will help with QCDN, attached, or, at least, how I teach it. Richard may have updated his program since I created the handout. There are links in the PDF to lead to where you

Thanks for the info Christina. My partner and I are just getting started with salted paper printing and Quadtone digital negs. Your books on the topics have been invaluable! So to confirm in regards

Thank you Clay. Will try that. Funny thing is that plates (DTP) printed fine before today. But yes, from what I've been reading in this group, seems that a carrier with a border is the way

This is a known issue with QTR when the image is too close the edge of the media. It can be mitigated by placing your plate (or digital negative material) on a larger piece of media so that you have

Hi All. Now that the 2 tramlines have totally disappeared, I was faced with this new issue this morning. The last bit of the plate seems to overprint without ejecting. Any ideas, suggestions as to

Enrico, They’re called ‘pizza wheels’. I had those too, until I found this article. This is for a P800, maybe it can help you with your

pizza wheel, you need to disable the star-wheel -- Kang-Wei Hsu https://www.facebook.com/HSUfineprint ( https://www.facebook.com/HSUfineprint ) download FREE preview ： Effect of Fixatives on

Paul I thought for sure someone would answer but this is how it goes: After GRAY_CURVE= should come numbers like this: GRAY_CURVE= "0;0 4;5 8;10 15;15 32;20 40;25 46;30 51;35 56;40 60;45 63;50 65;55