I¡¯ll answer this as I am the creator of the installer you are referencing. Jon is referencing a Mac workflow (installer script) so may have no realized you were on the PC. I hadn¡¯t realized that either.
Once you run the installer exe for your specific ink setup (in this case it¡¯s the P2 curves so I think you run the HD curve installer) you should be able to do the following.
1. Install the printer using the Epson 3800 driver.
2. In QTRgui select that printer (top right menu).
3. Just below that selection it will automatically drop to the Quad3800-UC curve selector.
4. Don¡¯t use that folder, instead go to Quad3800-P2 or HDP2 (I¡¯m forgetting, it¡¯s been a while since I¡¯ve had to deal with this) it¡¯s right next to the Quad3800-UC folder in the drop down.
5. Your curves will appear as selectable items in the curve selection settings.
best
-Walker
toggle quoted message
Show quoted text
On Oct 9, 2024, at 8:04?PM, Bill Roberson via groups.io <roberson_bill@...> wrote:
That's where I'm installing P2 curves from -- Piezography Community Edition -- but they're not showing up in the curves drop down menu when I run QTR.
On Wednesday, October 9, 2024 at 09:08:51 AM EDT, Walker Blackwell <forums@...> wrote:
P2 curves are found here:?
best
-W
On Oct 9, 2024, at 1:12?AM, Roy Harrington via groups.io <roy@...> wrote:
P2 curves are from the piezo products. They are not included with QTR.? So get them from piezo and install using their instructions.?
On Tue, Oct 8, 2024 at 7:22?PM Bill Roberson via <roberson_bill=
[email protected]> wrote:
This was corrected but now the problem is that I can't load the P2 curves.? It's showing an abbreviated list that is a different set of curves that print incorrectly, using channels that contain Piezoflush & shouldn't be used.? What am I missing about loading P2?? I even deleted the QuadTone folder left behind after an uninstall but that made no difference, nor did installing an earlier version of QTR.? No matter what I do the same incorrect curves are loaded in QTR.? Thanks for your help, I'm at my wits end.
