Re: QnetGateway instaed of G3
|
QnetGateway¡¯s ICOM stack was designed to operate identically to the G2/G3 gateway software. So long as the RP2C IP address for the repeater and gateway is configured according to the instructions, you would simply go about installing QnetGateway on the ¡°gateway¡± computer per the instructions. ICOM¡¯s default setup has 172.16.0.1 as the repeater and has the gateway system configured as 172.16.0.20 (which is the physical machine the gateway software will run on). The gateway system must have 2 NIC cards. One configured with 172.16.0.20/255.255.255.0 and one configured with your internet connection with all the necessary port forwards. ? My best advice to you would be to install a fresh copy of Debian Stretch onto the gateway system, configure both NICs, install QnetGateway, and everything should just work.? This obviously doesn¡¯t cover the actual configuration of the repeater such as frequencies and all that, but as far as the software end is concerned, its very easy. If you run into any problems let us know. ? 73 ? Colby W1BSB ?
toggle quoted message
Show quoted text
From: [email protected] <[email protected]> On Behalf Of nolyn78@...
Sent: Sunday, August 26, 2018 15:00
To: [email protected]
Subject: [QnetGateway] QnetGateway instaed of G3 ? Hello,
Just bought a used dstar systems: ID-RP4000V, ID-RP2000V, ID-RP2C and a gateway with G2 software. I needed help in setting up our repeater ID-RP4000V with the controller ID-RP2C using the gateway computer. I was told that I need to erased completely the G2 software to remove the old callsign. I already updated the repeater and controller but I need help on the gateway. I was told that I should look into QnetGateway or ircddb Gateway instead of G3 software because of linking capability. I need advice and how will I hook up the gateway if I use the QnetGateway or ircddb Gateway, will it be the same hook up as it is stated on RS-RP2C? Thank you.
Regards,
73, N0MIS
|
