开云体育

Hi Kees, I am sorry that you are having problems with the radio. I have never heard of this happening. J3 on the AF-Board is the connector that is used to send the audio to the front panel and swr

Jeff: I have a QRP ++ (sometime during original production the plus was factory upgraded and called the ++) with combo tuner/ps/ and charger in near mint condition been setting on the shelf here.

Hi all, I own a QRPPlus (1st edition) boughjt it years ago, sold it and now it is back again. But there is an issue ith this radio. On the second PCB (from above) there is J3 with some connections to

oops.. that is guy @ eastroad dot org Not dot com. 73 N1GMM

Jeff, I have a set. Please contact me at guy at eastroad dot com. I did send an email to you qrz address too.. -Guy

Anyone still have the QRP PLUS with the matching tuner? Trying to locate one that may be for sale. If you have any info please let me know! Thanks, JEFF WB8REI

Your xmit output is pretty normal.? Some rigs can get 5-6W out on CW, but 2-3W out on SSB is about it. As I recall, 100uV at the antenna input should give an S-9 reading.? A 6 dB loss through the

I have been troubleshooting my deaf QRP+ transceiver. It works on Transmit with 4W out on CW and 2W out on SSB. 100 uV on 20M gives about S-5 meter reading. I can barely hear 1 uV. I thought it

I have had as much fun with all my QRP rigs and am ready to part with many of them due to age and interests in other radio items. I have a QRP+ with matching antenna tuner and battery power supply

I give up!

Trying to get email from this list whitelisted!

Please ignore . . .

As I recall, CW output should be 4 - 6 W, depending on band.? SSB PEP output is less.? Haven't fooled with a QRP+ in 3 years or so. And my memory isn't what it used to be . . . L.

Thanks Larry.

Larry, you mentioned that with a partial failure, power output may be low. Is that in the 2-3 watt level or is it lower? My QRP+ does not get 5 watts but I would enjoy the extra 3dB if I could get

Expect at least 4 - 6 W CW, depending on band.? At least 2W PEP on SSB - might get 5 if really lucky. L.

I don't have a spectrum analyzer so can't check for spurs unless I sweep with my general coverage receiver. BTW What is the power Output with the pot turned all the way up on CW? And what PEP

If you are getting good xmtr output, it very well may NOT be the input mixer (SBL-1).? You can test further -- if you have some sort of spectrum analyzer,? check for spurious output (you might also

I measure 4 watts output when keyed from the rear panel. I have a new SBL-1 on order. Thanks for input. Wes

If the input SBL-1 is bad, your xmit output should be low as well. Larry - W1HUE/7