开云体育

I've patiently tried several.? Once negotiated the quality or not of? the? 9V? 15V etc is from the wall charger supply and as good as that is *Problems* The cable may output any available 'lower

Belkin, Anker etc are usually good.? ? ? Name-letter-jumble amazon Ebay etc 50Gbps 500W bargains less so

Thanks Curt and Enzo for the information.? I am using battery power to run the QMX + and the DC voltage is 11.8 volts. Sounds like I am good to go then. 73,? Doug

All seems to be well with my Ultimate 3S now. I misunderstood about the dBm power setting in the menu, thinking I could control the power for there (although I couldn't see how). Now if I understand

Its a speaker, not a fan ;-) I also have a small audio amp in there.

Tilting legs will be available in files section as soon as i get back to my pc in a day or two. I still need to do some finishing touches on model based on notes frome this proto and finish a speaker

I use exclusively a power-bank and simple PD trigger cable for my QMX and QMX+ power.? One is 12V, one is 9V.? They work flawlessly.? And the small Anker 10000mAh power banks I use are smaller than

Hi Paul, 1) turn back on your SWR protection to prevent damage if something happens. 2) your power supplies and bias current are fine 3) it should be pulling somewhere near 1A on transmit 4) although

Ah, I see we're looking at two different efforts here. Both of you: amazing work. It's delightful to see all the creative work happening around the QMX/+.

That is super sharp! I especially like the fan and external access to the battery tray!

Just a quick observation. Your current limits look low.Expect about 100 milliamps in Rx and close to 1A when Tx-ing.? Maybe set your current limit to say ...? 1.25 A? GREG KI4NVX? Yahoo Mail:

Would someone recommend a good well RFI shielded short (1-2 feet) USB-C cable? Hiroki AH6CY

Paul, is that a typo on your psu settings, or is that really only 70mA on TX? If so that definitely will give you low output. What current are you drawing as metered on your psu during TX? 73 Nick

Hi I'm having problems with QMX version 4. It receives fine, with no issues, but virtually no RF output. I can hear it in CW mode on another rig but it's weak. Using a current limiting PSU set at

When you do, remember to set the mode to digital, not cw. 73 Roger 8P6RX ?Get BlueMail for Android ?

Thanks to all who have chimed in on this thread. A special thanks to Pierre, VE3HQZ for the detailed description of his process.? I am now armed with the knowledge I need to proceed with the QMX+/Mac

Gust, I didn't mean to put you off from trying PD power banks. They do work quite well. I and others on this forum are using them successfully. All solutions have quirks. You just need to be aware of

Good results have been reported using copper spray paints like these: https://mgchemicals.com/category/conductive-paint/conductive-spray-paint/ The nickel might be cheaper, the silver might work

Merry Christmas Joe! N1MM+ works quite well on the newer M processor Macs by using Parallels and installing Windows 11 Pro ARM in a virtual machine.? USB drivers are different for Windows ARM vs

Thank you gentlemen, knowing this I decided to not bother with a power bank PD solution. 73 es dx