开云体育

Hans...& others These QRSS beacons (and the grabbers) seem to be popping up on many bands and on many frequencies. This seems to suggest that we each need QRSS Beacon transmitters for all bands,

Hi all, I lied about the pull ups....i really meant pull downs...sorry. Steve -- It is vain to do with more that which can be done with less.

Hi all Just some comments regarding the recent keyer chip thread: 1) Do NOT use 10K pull-ups! It won't work! You need pull-DOWN's! Not up! If you see this problem, then you can connect a 10K

Hello Neil and Paul, I had the same problem. Once I grounded the unused pins as Hans suggested all was fine. 73, ---Paul AK1P ________________________________ To:

Neil I have gotten the same thing with my PIC keyer chip. Hans suggested grounding all the unused pins on the PIC. With the jumper for 3Sec dots it seems to send the call at 12 WPM once every few

Hi guys, I think there is some variation in the ATTiny13 keyer chips. having programmed over 150 of them with the software using exactly the same programming arrangement I would say 1 in 10 chips

All, This is very interesting because I had same issue. I was also just monitoring my signal and mine just set the NDE of M0NDE fast then carried on ate qrss. Please confirm connection you made

Neil G7AQK I had to add 10K pull-up resistors to the speed selection jumpers. This solved my problems with unreliable setting of speed, and other strange behavior. Arv K7HKL _._

I just finished putting my 30m QRSS kit together yesterday evening (certainly more interesting than X Factor) and every thing seems to be functioning. I have run the keyer in its default 12 WPM

Thanks for the links Arv. The current indicator certainly looks simple enough. Neil

Neil G7AQK These URLs might help: <http://sites.google.com/site/arvidevans/bare_minimum_z-bridge> <http://sites.google.com/site/arvidevans/antennacurrentindicators> Arv K7HKL

Does anyone have an easy method of matching your antenna to the 30m QRSS beacon? My SWR meter is not sensitive enough to work with the beacon kit and my QRO rig does not do 30m, but I do have a 30m

Thanks Hans... probably explains it. 72 Dom M1KTA

Hi Dom I wonder if that is AGC action? It'll be a massive signal into your receiver and probably the AGC either in the receiver, or in Argo, will take a little time to adjust to it. That's my

Hi all, Just managed to get a 30m kit built. Just testing into a dummy load right now. When apply power the signal is spread over maybe 10Hz initially (wide band) after couple seconds it calms down

Hi. Having few spare time in october I just finished assembling the beacon kit. Everything seems running ok but I am not happy with the 2N7000 bias setting. Running the beacon at 5-6V, even with the

Beacon was on the air last night with 3 sec dots on about 10.14070. Using the CW mode (upper side) on a FT-1000 to read the Freq. Keyer seems stable and is reverting to a 12 wpm ID every 10 min or

Hi Paul As others already noted, the table is peak voltage, not peak-to-peak. That's where the missing division by 2 comes from. Also bear in mind that table is for 50 ohm load. You were using 36

OK on the power formula and the P-P vs. Peak Volts. Will work on antenna connection and move it to the slow speed. Paul K3PG

Guys, FWIW the formula for calculating RF power into a 50 ohm load from the peak to peak voltage observed on a scope is :- Power = 2.5 x (Peak to peak voltage squared) milliwatts So if you have a