Hi all,
Just managed to get a 30m kit built. Just testing into a dummy load right now.
When apply power the signal is spread over maybe 10Hz initially (wide band) after couple seconds it calms down and is a single signal.
Is this normal?
Run the output through a splitter/tap into a digital oscilloscope that also works as a spectrum analyser and I calculate 56mW out.
Argo displays nice clean signal abt 4Hz wide.
PSU BTW is an ATX PSU, added lots of chokes and RF clean now. 5.12V
I can see small variations in the signal though and if I monitor the output using ARGO.
72
Dom
ON/M1KTA
