开云体育

Something like that happened to me when my battery got close to the end. Seems that at the initial key down there’s a power drain beyond my limits. Changing batteries fixed the problem. I was

Has anyone else seen an issue where the receive audio stays on during transmit? I noticed it today. It happened on all bands and when I key the mic the receiver audio doesn’t blank. It’s not

Check that the tab on the display is bent over and not shorting the capacitor on the PCB. ?I went round and round on this symptom until I found it. ?You will have to carefully remove the display

Thanks Muhsin

It's all good. The height of the cycle. In a few years we will need a few more watts!

I had something similar.? Turned out to be the battery charger in next-doors RV.

Pierre, good plan to mount the IC’s on sockets . I did so on my QCX kits. Worked out great. Enjoy the build. Gary

Can anyone recognise qrm in attached picture? Signals are spaced around 40khz. It shows up randomly, no specific time patern so its hard to pinpoint the source.

Stan,? Yes, I'm sure about that. After I read reports of that I checked for tones and birdies. I found a few birdies here and there, but not these tones. They also were not there at first with the

If you recently used the QMX+ system menu to switch from USB to LSB, that could be the problem.? If you did, and it is set back to USB, try setting it to LSB again, exiting the menus, then go back in

Mike and Gary, Thanks for your comments. Building and then repairing the QDX was the most I could do. I'm using a soldering station set to 750°F with a very fine tip. I've carefully studied the QCX+

I just had the same thing happen on mine. 3 kHz off in Digi mode. I have no idea what sequence of events triggered this or fixed it, but it's a bug of some sort in Hamlib, WSJT-X, or the QMX+

If you are using a fully charged bioenno "12V" lifepo battery,? you are likely putting in well over 13V to your QMX+, and your voltage protection is disabling your transmit, which also disables the

When this happened to me, it was because I had forgotten to put it in CW mode. It was in DIGI mode! Ellis GM4GZW

How do the terminal mode diagnostic tests look? Don't forget to run the button and knob checks as well as the paddle check. Be sure the setting for what paddle mode you are using is set in the menu

Many thanks for these suggestions Stan. Jim

I received my QMX+ unit preassembled a few days ago. I just want to use it for CW, be able to hear the sidetone, transmit, receive, use the automated messaging to call CQ. So far I am not getting any

Jim, it seems that there is plenty of time before July for us to help you get this figured out. Reading the reference Ludwig pointed you to is very useful. Something is probably shorting inside your

Ludwig, I am glad to have this reference for later. As I read it, it assumes firmware is installed. I cannot get my QMX to mount to my Ubuntu computer so that I can install the initial

and note that the band select should send the RF through only the selected coil, not through the others, so you shouldn't see it on the other output pins of IC408 or the other input pins of IC402.?