开云体育

I just stuck a thin coffee stick between the knob and the case and secured the knob.?Adjust as needed.?Do pull out the coffee stick when you are satisfied with the clearance. :)? GREG Yahoo Mail:

Might help to include a couple spacers with each kit with instructions to stuff them into each knob before mounting to the encoder shaft. Perhaps a metal or nylon hex nut would do. Jerry, KE7ER

Cans of worms often need opening... If only to let in some daylight. I started a thread earlier about the same subject, but didn't get much help on settings. What I have found is if the AGC

You can indeed find the QDX and QMX on AliExpress. They strike me as some awfully bad copies.?

Test 1 is supposed to generate about 3V on the VDD rail from the linear regulator IC101 but if D109 is low resistance it will current limit at whatever your PSU limit is set to.? However 300 Ohm is

No dealers for QRP Labs radios. They are sold directly from QRP Labs website. Hans ships worldwide using DHL or FedEx.

Group- Hope this does not open a whole can of worms, but what are some good-sounding AGC settings for CW ops? I'm in a high-QRN area. Thanks & 72 Jay W6CJ

Group- I'm trying to familiarize with all of the CW filter settings in the latest QMX firmware. (Sounds great). I have the manual. Suggestions appreciated Thanks & 73, Jay W6CJ

Hi, you can order it here: http://shop.qrp-labs.com/qdx ( http://shop.qrp-labs.com/qdx ) directly from QRP-Labs I don't think you'll find it anywhere else, if so it's probably a bad copy. -- Lasse

Hello, Is there an European dealer for the ?QDX - Digital Transceiver.? No Ali Express. Regards,

Lasse, will get right on that this morning! Will advise... -- 73 Karl KI4ZUQ

Please include me in another group buy as well. vy73 de DJ1TG Thore

Roger, that. Hope it works out for you. GREG Yahoo Mail: Search, Organize, Conquer

Dear Ludwig, thanks so much, just now notice your reply. Already did the test and it indicates problem with D109. I'll reply to your PM. Have build successful more than 10 different QRP Labs kits,

To be sure i removed the knob and it's more wobbly than the other. Maybe I've been pressing too much in menus :-) but it looks like it should be "easy" to replace -- Lasse

Thanks, then I know what to order from eBay? :-)

GM Tom, Are the buttons only active during the events or perhaps they just don’t work on an iPhone? 72, John KK4ITX ?Each mistake is a learning opportunity.?

Great catch. The Q's are terrific radios.? Greg Yahoo Mail: Search, Organize, Conquer On Sun, Jan 5, 2025 at 9:00 AM, Richard KC1TXA via groups.io<pendragon60@...> wrote:

Just a quick thought ... Any chance the knob is down too far on the shaft and not allowing full depression? (This is assuming that you have the unit in the enclosure? I ran into the same issue in my

Thanks. Started poking around the pot That was not it! ? Further poking showed that it was very slight pressure from the Ear & Mic/paddle jacks as they exited the front panel which was causing a