开云体育

Hello ED ES ALL, Your invite got me out to my backyard for a “portable ops dry run”, so thank you for the inspiration. ?Unfortunately prop did not seem to cooperate to reach South Florida.

Would also be interested if anyone decides to kit... if not, I may, with permission, try to put some together, but that would probably be at least a few months away. Bob KG5GTE

Besides the QRP-Labs 10w kit, which I see was discussed on another group as an option, (and qrpbuilder.com is using one on 6m, reportedly), there are options from 60dbm.com. Not the cheapest, but

On 1/2/25 I had a CW practice / rag chew session on 40 meters. I worked three stations: Conditions were very poor. SSN = 163, SFI = 219, A = 86, K = 5 so the band was pretty noisy. I will be doing

Hans, Looking at web hits for PCM1804 failures other than on QM* products, I only see low level noise issues. What's being reported in this forum is complete failure. A 15% failure rate is

Please include me in the next buy. Many thanks and 73, Mitch NK3H

Hi Chris, I am not sure why there is a difference of peak voltage on the lower frequency bands unless it is due to higher gain at lower frequencies. I would be hesitant the to change the finals in

Tiny SA is fine for HF - VHF harmonic level compliance checks *PROVIDED* that you know what you are doing. Basically there's a *very* narrow window of absolute input powers where both a main carrier

It makes more sense to make the change on a QMX+ since on 80m and 160m the peak voltage, even with 1:1 SWR exceeds the BS170 maximum voltage rating.

Hi Curt, I can't see why a tinySA wouldn't do the job, I think that its dynamic range is 70dB, that might not be good enough to measure the good quality cavities of a 2m repeater but plenty enough to

As Harold mentions, it can be done with TN0110s, I've done so in several QDXs. But I would NOT do this in a QMX. -Nate N8BTR

I'd like to acquire a 10 - 50 watt linear power amp to use with a 50 MHz. beacon transmitter. Input must be in the 10-18dBm range. Kit or assembled or "needs repair" is

No it would just be difficult to make it work

Why not just get a transverter? There was a ham in Ukraine that had a store before the war started. No one else seems to be interested in picking up that mantle (that I’m aware of).

Did not investigate the component TN0110 further, but may provide opportunity in combination with an "U" shaped heatsink instead of a washer when installed in a neat way. Harold PE1RJP - Happy QMX+

I’m interested in one full kit, if another group buy happens. Thank you for what you do! tom KE5CW

Rick, the 0603 size (first checked item) would be the easiest to work with. If you have a small leaded 150 ohms resistor, you might be able to solder it in that spot if clearances work out too. Good

Hi all, I was trouble shooting a problem with my QCX mini for 20m Rev. 3 board T1.09a When I would push down on the tune rate knob or even? touch the knob to adjust the volume the volume would drop

We had eleven folks at the 26 December Michigan QRP Club weekly Zoom chat. Please join us Thursday January 2nd (and every Thursday) at 4PM Eastern for the Michigan QRP Club weekly QRP Chat where the

Stan, Guess I won the dummy award of the year on the 1st day. The QMX+ was in Digital mode. Set it to CW and all is well! Tnx, Tom KT4XN ________________________________ Sent: Wednesday, January