开云体育

Question about that wire stripper Dave. Do you have an assortment of blades? Comments on Amazon say it’s not effective on wire 22awg and smaller.

Thanks for the advice folks.? As I said, I'm a beginner, though I had heard about RF chokes.? I've done some research today and found various versions of chokes, including this rather tiny

Inspired by the RSGB work (May the Morse Be With You) I've been successfully demonstrating the joy of Morse at STEM events I organise using my Morserino and the LICW Haptic device, it's especially

Hi, may I relate my PA-story? I built the 50-w-pa for 80 m successfully (I think? ;-)? ?). Yday evening I did some QSOs wid abt 25 w (power supply abt 14 V). My rig is the QCX mini. All was

Boom.? Best suggestion yet for building this kit.? Thanks!

Bekir, Wow, this is timely. ?I picked up a QMX+ at a ham fest this last weekend. ?This kit was in an estate sale for an SK that never started the build. ?I’m eager to start, and now I’m

Good morning/evening Chris. Great advice, thanks! ?I’ve been working away at checking for continuity as you describe and re-flowing/re-soldering many leads. I agree, I need to lower the voltage

Thanks for that tip Dave! That’s a very useful tool, I’ll check it out. 73, Brent VA3YG

Good morning Stan and thanks for this info. Last night I started to reflow the solder on a couple of the leads on some toroids and double check continuity with my dvm. ?I have suspicions about enamel

Hi Paul, yes, I bent that over to 45 deg as per the instructions ?. I’m going to inspect the fit more and apply electrical tape in a few spots. 73, Brent

?I am going to g to throw this in again for those who haven’t seen it. It’s my choice for stripping magnet wire. Every builder should have one. KNIPEX Tools - Coated-Wire Stripping Tweezers

Excellent news. Now the Tx.? If you are receiving well then T507, the LPFs, L401 and T401 are all connected reasonably well. A bad connection to L502 or T501 could be why there is no Tx. Try

indeed poor Condx but I had a bit more luck 13h on 30 m ON7DQ,, PA0CMU and OH8TX? and 19h 30 m closed but worked Scotty GI0BEY and a non QCX from DL on 60 m -- Martin DK3UW

Should be close now! -- 73 Karl KI4ZUQ

No transmit on all bands is usually either a) one or more bad connections to the leads of T501, or the center tap twisted lead of T501 not contacting both wires; or b) the primary single wire going

Re: your intermittent display-- There's a tab on the back of the LCD display that's supposed to get bent over some. It's described in the build manual. Was that done? :-) Else, look for tight spaces

I finally bit the bullet and bought a NanoVna-2N. (It has N connectors rather than SMA).? It came with N calibration connectors and cables.? I also bought N-PL 239 and N- BNC adaptors along with

Thanks Paul. Well, it’s got great receive but no transmit output right now. I hooked up a QRP wattmeter and dummy load and there’s ever so little wiggle of the needle at 11.5 vdc. It’s like you

This is after rewinding T501 with RWTST method. It seems to have helped ALL bands! Should I redo my QMX? Does it matter if #28 AWG is used? I saw recentlu that #28 is supplied for everything

This is putty results right after completion. -- 73 Karl KI4ZUQ