开云体育

Correction, see this link: /g/QRPLabs/message/115012 -- 73 Bojan S53DZ

Hi Matt, the?switching LSB/USB seems to work only via CAT. /g/QRPLabs/message/116292 I suppose it is on the Hans's ASAP table to solve. -- 73 Bojan S53DZ

A new chat has been created: Hi, i?ve got a good working QMX , 80m-20m. CW wonderful, digimodi perfect :). Receiving HAM Stations in SSB on the 20m band works good. I can listen to the

Hi again! And thanks Tobias! I agree with Jo. I think that the QMX:s we have probably are "fundamentally right" which can be proven by working a lot of QSO:s and enjoy. The proof of the pudding is in

Hi Tobias and thanks for chipping in! I created this topic hoping to get an answer to the same question you have; something fundamental wrong // or not? My sweeps and numbers looks very similar to

Hi Jim I do my best OM, I really work long hours at all this - but there are a lot of things on; The priorities for firmware are currently fixing the CW keying glitches, and adding AGC. If I had a

Thanks for your replys. The only thing inactually touched was swapping 11m for 30m in the config. Rx is fine downnton40m. Will checknlower band edge of 20m :-) and report :-)

You've swapped the encoders and the problem persists. There is no firmware issue that could cause this. The conclusion must be, some kind of connection issue somewhere between the microcontroller

Have you done a Factory Reset yet? What version of firmware are you running? (If you have done the reset, don't think there's any point in doing it again...) Paul

Hi Guys! This is my first post in this forum, and my fresh QMX 10-20m build seems to roughly follow the pattern that are posted here. QMX high band rev 2 RWTST transformer 12V 1_00_014 50Ω 5W QRP

Hi Muhsin Please see previous reply, I already explained this. What works best in practice and what is predicted by theory is not always exactly the same. Calculation, modeling, simulation is all

The original problem has resurfaced. It did not move with the encoders. I put the left encoder in place of the right, and right in place of the left. After this, initially turning the left encoder

Hmmm... That it /moves/ with the encoder, is rather incriminating of the encoder... Did you say that you've replaced the encoder once? You might check that the switches on the encoder are opening

Paul - the CCW seems to have resolved itsself. Maybe I was seeing ghosts. I swapped the encoders and as before the right side functions correctly. Now turning the left side is unresponsive in either

Put the keyer into straight mode.? Then simply hold down the paddle.

Hi Nino, Brandon-- Some random responses on my part: * I too have noticed that, when the frequency goes too far up or down, it gets "stuck" and requires a power cycle. Reported to Hans. * SSB

Hi Brandon, Today I replaced the right encoder and the situation is still the same. In my opinion, it is not a hardware problem. Perhaps there should be something wrong with the board or the

Version 12 of what? 72 / 73, Bill, N4QA/4 in OKI; previously WB4HIO and, before that, WN4BJC

Using version 12. Is there a way to lock into transmit so I can measure output and/or activate a QRP tuner? Thanks and ‘73 Jim WX8J

Sounds good to me, too! JZ