开云体育

Great news, and good work Hans! -- 73 Ingy M0MHJ

Hey all, recently got my first QMX kit delivered and noticed it included some .6mm wire, while most docs are saying it isn't included on newer kits due to better performance. Is it worth to get some

That looks like a good fit for a 12v build, so long as you don't transmit while the batteries are charging. When charging, each cell will have a max of around 4.2v across it, plus some for a series

Wonderful news Hans. Thank you so much. I can empathize with the task of documentation. I am in the middle of that phase with a project at work. Thank you again for all you've done. Can't wait to test

Bryan, Maybe just copy your last post, description of problem, to a new topic with suitable subject.

Great news. Just in the middle of a Tony Robbins Motivation "Power from Within" Seminar. Hans, you definitely fall into the "outstanding" leader category. Outstanding chaps "take it all". Don't worry

On 3/15/25 I had a CW practice / rag chew session on 20 meters. I worked four stations: Date / Time Call Mode Power Bnd Frequency Snt Rec Name SPC# Comments 3/15/2025

I have been using

I guess this thread has drifted off topic. Sorry about that guys. Is there a way to fork it to a new topic? -- regards, Bryan, N0LUF

My advice: Just release it stating it's for the adventurous, just enough documentation for now. Step back for a week or two, not engaging much with the forum. Let the inevitable complaints come in,

I run my 12v @10.5 using a buck/boost it's happy!

Alan, The sound,? when using a head phone,? Is very similar to using a stethoscope.? It's a soft squishy sound similar to a heat beat keeping time with the yellow blinking light on the gps. The

Don, Good stuff! You are drawing zero current from that LP2950-5, they probably set it a bit high so that when drawing max current it is not too low.? The last tenth of a volt does not matter

Congratulations on coming to a decision on your implementation of SSB for your QMX hardware. Incredible job, you are the man. What an education this has been for all of us. 73 Kees K5BCQ

If you needed another reason to attend FDIM/Hamvention, what better reason than seeing/hearing/chatting with Hans. 73, Rick K8BMA

Jerry, you are far faster at responding than I am! Looks like I repeated most of what you said :-) Actually, my output voltage was 12.012 volts. I used 1% surface mount resistors and checked that

When you solder something using 60/40 solder, there is a mushy state as it cools down where the solder is no longer liquid but not yet a solid.? You need to hold the parts still when it's mushy or

Luis, Although much simpler, your circuit would induce about 2.5 volts of loss and a higher quiescent drain (5 mA). When the voltage from the battery drops to 14 volts then the output of the regulator

Hans, Take some time off, get rested, and then come back to it with fresh eyes, before you release. Anyone that has ever released an engineering product can tell you that you may have thought you

Bogdan, I haven't seen the article, but that does not seem too worrisome. Hans has found that when he changes the PLL (or VCO) feedback multisynth divider, it transitions quickly (and I assume