开云体育

Never mind, I think it should be way easier to just use a small MCU board that supports USB host/HID to implement ascii to cw symbols. This way any USB keyboard can be used. K3NG keyer seems to have

I set up the Qmx+ for Wspr mode. I’m using the internal qlg3 gps. It seems to switch out of normal cw mode and show the WSPR screen at the proper intervals but I don’t hear the tones indicating it

The USB port on QMX is a “USB device”. To use a USB keyboard, you need a “USB host”, like a computer. A much more feasible way is to build your own keyboard with keyer implemented in the

I just tried WSPR mode on my QMX+. It works fine but it seems that the front panel controls stop working while WSPR mode is enabled. I could not enter the menus or even power off. I had to connect

I'd like to expand this to a more general discussion of using the ProgRock2 as crystal replacements in vintage crystal-controlled gear. I have a 1960s military CW-only manpack transceiver, the TRC-77

Most if not all of those tuners have a relay to reverse the input and output connections to accommodate high- or low-Z loads.? While that switchover is occurring there is a practically-infinite

Ok now I see some cool options. Since Hans started QRP Labs I have struggled with his decoder entry system and said to him, "Why not a keyboard?" Now he has a USB porr. For emergency field operating

I have not yet got a QMX+ but in the meantime I have been reading and wondering about power supplies.? Has anyone tried a LIpo 3S battery, nominally 12.6V wehn fully charged and drops to about 11V

I think you can still buy a DJ0MY nanoKeyer kit that has a PS/2 port. I have one of these and it works really well. DJ0MY also provides the gerber files on his website. It's too bad the widely

I've enjoyed building several K3NG keyers. They're great for practicing CW and even have some built-in drills. I've not built the keyboard option for the K3NG, but it's clearly documented. It does

Or maybe I will see if having a keyboard USB port and a keyboard option in the Keyer menu is possible so I can talk to my QMX+ easier. Hans may add that to the list, so I can edit messages without a

Thank you Tom and John. I do love my straight keys. I have been in practice mode a lot lately. at my speed they are fine. I would never stop using them. K1EL was sold out, when I Googled it. Not sure

Old thread.? If you are looking for crystals, try here: https://yhst-172765969-1.store.turbify.net/index.html -- Chris / W2BPL

George gQQgle "CW keyboard" returns several options 72 73 John N3AAZ

Howard Thus may be part of the problem. - Though not the fault you’re now trying to identify When you’ve completed the other test steps can you describe this set/up in more detail

Hi Samantha. Not quite the original posted situation I think but yes this is a regular peril where some auto ATUs and their ?‘just try all the possibilities’ first stage algorithms meet

Hi You’re looking at the top of the PCB The holes the BS170 leads go into are actually little plated pipes electrically linking the top and bottom of the PCB even before you solder You solder on

I had power output loss on a qdx (same architecture) when txing into a resonant antenna via a tuner.? Sometimes my at-10 would decide to do a tune cycle if it detected the swr creating up over 2:1.?

hi, I just looked in the QMX+ Manual before I start my build and I noticed on page 25 (chapter 2.8) that on the picture all BS170 are only 2 (out of 3) pins are soldered to the PCB? Is that intended

Hello Andreas There will be delay, there always is, where USB is involved. But we aren't sending 1pps via the serial port anyway; so in any case, it's an approximate time setting not high precision.