开云体育

1 works, 2 works, but 3 ports results in no com ports. Tony AD0VC ________________________________ Sent: Friday, April 25, 2025 2:17 PM To: [email protected] <[email protected]> Subject: Re:

I'll move it to the right button... 73 Hans G0UPL http://qrp-labs.com https://buymeacoffee.com/g0upl [email protected]> wrote:

Pressing left-button during power-on (or while QRP Labs is still showing on the screen) will cause the EEPROM to be completely cleared.? This is a design feature - perhaps it would be better

Sorry, Hans, I didn't realize the code was being changed as I typed.

Hi Stan 1_01_006 is on the website... so let me know how it goes! By the way - all noted on remembering the last-visited sub-menu selections, leave that one with me. 73 Hans

Mine doesn't work with .005. The serial port is not recognized. Win11. Back to .003, everything's fine.

Hi all I updated the SSB beta testing webpage of the brave, here: https://qrp-labs.com/qmxp/ssbbeta.html and released firmware version 1_01_006 to it. As discussed in the other thread... I believe I

Except in the current 1_01_005 I have the same problem as everyone else, the USB device is unrecognized due to 'Configuration Descriptor Request Failed'.? The fix you just made should remedy that, so

You mnade me do it. Booted my W11 machine. Less than 1 minute to log in screen. Probably 90 seconds until I was typing this email. Tony AD0VC ________________________________ Sent: Friday, April 25,

Hi Stan Then I expect that should also be the case in 1_01_005. My Win10 is very old, remember. In Linux I see the three ports and Audio no problem (and USB Flash drive, if I enable that in the

But for some of us, all 3 ports were working fine in Win10 (fully patched Win10 home edition) in 1_01_004.

For reasons best known only to itself, Win 10 didn't do any patching even though it's been years since I used it. And it even seemed to boot in only about 7 minutes which is much faster than I recall.

I meant that I just used PC speakerphone - air - QMX microphone instead of USB cable to transfer audio from PC to QMX ))

We will hear from you in a few days after it finishes patching...? ;-)

I used USBTreeView to look at the QMX USB port with 004 and 005 installed. In case it might be of use, I attached the output as two files, one for 004 and one for

Hi Matti > Could it be that in Windows the data and command endpoints must be No. Well yes... But with the COM ports = 1 setting it is supposed to replicate the precious situation. Anyway I found a

Hi Tony Well, for fun, I reinstalled 005 and ran the calibration from the front A problem is that everyone's machine will be slightly different. When I get the next beta out and it works on Windows

Well, for fun, I reinstalled 005 and ran the calibration from the front panel. Phase works better but I still have one (30 Meters) that does not complete. I went back to 004 so that I could look at

Could it be that in Windows the data and command endpoints must be allocated pairwise? Or Windows requires that command endpoints must exist even if not used. -- 73 Matti OH6BEX

yes, I'm sure that is the case. Must have happened during the factory reset just as power dropped showing a blank LCD. I've ordered another IC2. Jeremy