开云体育

Pawel, I have had this happen also, it is not the SSB software but I think it is ESD from our fingers causing the processor to go "off in the woods". Someone showed how he put a ground shiels over the

I'd like the name "QMO" for a 50+W version. ?

Gary, I'm not convinced that it is simply random. I was able to return the settings to default, or another intermediate experimental setting and repeat the calibration, getting consistent curve

Also, on JP106, there is no power. [email protected]> wrote:

Hello my QMX after installing the latest version of the beta software for SSB has become completely deaf on 20 meter band. In transmissions everything is ok, the other band are ok also in reception-

Just the power-off/power-on sequence.

On IC101 it goes to 3.2 then 1.7 volts when. I press the button. It draws 0.7 amps when pressing the button. [email protected]> wrote:

Hello I think I found a software glitch. I have QMX+ connected to the logging software, having fun in the CQ WPX contest. From time to time, randomly (without any particular scenario), when you turn

Very glad you have it working!? And yes, it would be nice to have a scan function, or a panadapter to see where signals are. Actually, for CW mode, you can connect the QMX to your computer, enable

Hello, I am testing ARIM + ARDOP between QMX+dummy load and TS590+normal antenna. I can hear both signals both ways very well. ARDOP listening to QMX can decode all frames. ARDOP on TS590 cannot

Hello to all, is there a hardware reset for the QMX? THANKS

Hans just keeps making it better. Well worth the $$. Mike Krieger [email protected]> wrote:

After removing IC503, I'm able to power it on normally. Terminal app shows both SMPS modules are working fine. I'll order a few ACT08s and test the TX/RX when they arrive. And I'm going to build the

Hi Ludwig, Thanks for your reply! Sorry my bad. I thought 5V had a linear regulator as well. What I observed was that after long-pressing the power button, the LCD would turn on normally and show

Adjusting the band edges makes no difference as the test frequencies are fixed. ?It is most likely that running the calibration over and over as you change band edges it might just work, but you

Got it , I was on 50 M after my upgrade trying to practice code.? And I had disabled 160 an 50M so I do not accidently Xmit on them as my ant does not do them, apparently this also disable practice

Hi Stan, thank you so much for your analysis! I used a fixed 12V PD trigger, so it's probably not the 20V issue. I'll take a closer look later. You're absolutely right! I realized this as well. It

Brian, if this works when you can't switch on your QMX without the USB cable something is wrong with your setting / your QMX!!! 73 Ludwig

Jindra, Right now for the beta, a) You need to use an external mic.? The internal mic is not currently supported.? While the internal mic does have some functionality, it won't work well for QSOs -

Sorry, failure. It should be: Strange. In some failure situation going to Diagnostics may reduce input current. Do you know your supply voltage every time? 73 Ludwig