开云体育

Thanks for that Rod, I am still experimenting, will try your method, Cheers Martin ________________________________ Sent: Thursday, February 22, 2024 10:07 AM To: [email protected]

Thanks, Ludwig, good question.? The ViFly, with no load connected, registers 40mA on my bench supply's meter, same as with the QMX connected.? This implies that the QMX isn't drawing anything, so I

Thank you Adrian. The IQ mode is not enabled. Also, I tried a factory reset but the issue remains. 73, Matt

I really do not want to drill them, either. So, you actually got them to clear with the solder wick? "I soldered a capacitor in the wrong place on one of my kits and managed to successfully remove it

I am looking for an OHR Explorer II from the 1990s. Does anyone have one ? Kris KM2KM@...

My guess is that this is a firmware bug. My QMX Low Bander does the same thing if I leave it on over night. Hans is making great progress though with all the updates:)!

Hello, Isn't the "IQ mode" setting in the "Digi interface" menu enabled, by any chance? If not, you may also try a factory reset. Regards, YO3GFH op. Adrian

Hi OMs I could not remove the original problem - a large current on the receiver (about 168mA), but I use the QMX radio in both DIGI and CW mode and it works fine. I tested the radio again in

Additional information: using terminal - Hardware tests rotate the encoder in a medium speed the arrow shown is ok but sometimes for a moment an arrow in the wrong direction is flashing up

I finished assembling a high-band QMX on a 2023 Rev 2 board. First power up, no smoke! Everything seems pretty good except for when I tap the left encoder to enter digital mode, a horrible screeching

Be aware you need around 160 mA to start the QMX.

Thank you so much, Hans, for the reply. I really appreciate your customer care and especially your responsiveness to your vast?market. CharlesK5KXJ

Which current if you remove the power connector from the QMX? How much power consumption by the ViFly ShortSaver 2? 73, Ludwig

Hi, sorry if this topic was discussed before but I couldn't find it. Yesterday I finished my second QMX (20 m - 10 m). I found problems related to the right rotary encoder. When dialing the

The QRP Labs ecosystem is a great place to live. -- Chris / W2BPL

I finished construction of high-band QMX rev2 (2024), 9V version.? Checked and rechecked all my soldering under magnification and probed for shorts with an ohmmeter.? Time to apply power and do the

Firstly please don’t drill the holes out. It’s a multi layer board and there may be inter-layer connections, I don’t know for sure but just saying. I soldered a capacitor in the wrong place on

In this URL you can find the method used to measure the output impedance. https://www.hamcom.dk/VNWA/VNWA%20measurements%20of%20PA%20output%20Z.pdf

No, I did not. I'll look into that as well. It may be Sunday before I can fiddle with it, but I'll post my results here. Thank you!

I have cleared solder holes by simply heating the pad and displacing the solder with a toothpick. Sometimes it helps to whittle the toothpick to the right diameter. 73, Bob W7DIT >