开云体育

Hi Daniel See QCX manual page 115 re "Tuning Clicks" 73 Mike G0CVZ

Hello Micheal. I had a similar problem in 20m trying to get the drift stable. Before doing anything to the rig, I used to get awful drift. Really to the point of getting zero spots. -4 -3 were very

Well that's promising. The first 8 spots after getting the PA lined back out had 0 drift. Maybe the brass donut did the trick. on 80m the same rig was drifting between 1 and 2.

Well... I put the U3s on the bench, hooked up the oscilloscope, and sure enough, output with (3) BS-170's and a little over 8V was only a little over 100mW. I moved it up to 500mW. We'll see how it

Well after connecting the control wires and then checking everything again to make sure all was what it was supposed to be I connected the U3S to a dummy load and hit the switch. Everything powered

David Has it started properly at all yet? I had mine going but was having the issue of not starting first time but only on second power on. At one point when I was powering on and off to test possible

I’ve tried the fix but no luck. I have two lines of bars with a pulsing thin line that moves up/down through the bars.. Thinking IC2 is not doing its job, but the pulsing makes me think there is

Should I reset my PA bias after switching bandpass filters?? I wouldn't think so. I ask because I had about 500mW with the 80m filter last night and now on 30m I get 100mW. I set the bias with my

OK Hans, I will check my WSPR signal by myself. Thanks. Hidehiko.

Are you still having issues what is your exact fault BR Andrew Sent from my Windows 10 phone Sent: 25 October 2017 22:10 To: [email protected] Subject: Re: [QRPLabs] Problems with Relay Kit So as a

The shaping and control connections bring on the supply to the PA transistor via the shaping circuit. BR Andrew Sent from my Windows 10 phone Sent: 27 October 2017 20:53 To: [email protected] Subject:

That's great news to hear. Glad it's up and running. All the best. James. 2E0MUA

OK so it turns out I need glasses... I'm not even joking here. When I got the magnifier out I had SOOOOOOO many issues, re-soldered most of everything and we are back working. Thanks again to everyone

Thanks, Petr I'm going to get one of those. Marc WB2MSC

Daniel, Similar modules use a large capacitor, 0.08F. The one I tested did not retain charge for long but enough to retain the satellite data for a few hours. This could work with the QLG1. I

Hi all, I now have the V3.12 controller chip set up and working in my U3S. I have the 5 watt PA built with full assembly. My question is if I leave the PTT and the Cosine Shaping in a non-active state

Hi all This refers to the issue which has one or more of the following symptoms: 1) high current draw on transmit 2) low or unstable power output 3) dead MPS2907 The first batch of 500 kits used the

A perfect opportunity to practice methodical troubleshooting and narrow down the possible culprits, half the fun of building kits (: simon.oliver90@...> wrote:

I can confirm that my QLG1 charges the battery to 2.9V with a GPS supply voltage of 3.3V. It does not last very long thou, a few minutes to discharge down to 2V. I believe this is the reason I doubted

On 10/27/2017 2:46 PM, Hans Summers wrote: Hi Jim Just set "6.1 Beacon" to "ON". This means the QCX will power up in beacon mode, and start operating as a beacon in whatever mode you configured (CW or