开云体育

Edit: Maybe I am just overloading the 6400M front end, but my Hermes Lite 2 doesn't sound like this when I listen to it in the same way.? Did try 6400M TX to QMX, SSB RX in the QMX sounds great.

Hi all I updated the SSB beta testing webpage of the brave, here: https://qrp-labs.com/qmxp/ssbbeta.html and released firmware version 1_01_003 to it. These are the changes: 1. Bug fix: Initial

Hi Group, I took the plunge today and installed the second SSB beta FW on my 80-20m QMX.? Did the calibration and tried it out.? While I do hear myself well on my nearby Flex 6400M with no antenna,

Hi, Thanks for sharing your audio setup. I adjusted mine and sounds better. Before I just made my 1st SSB QMX+ QSO. Portugal - Slovenia. With 3W on 17M, a long wire, 9:1 UNUN and an ATU-100 tuner,

Thanks, I suspected as much. Currently my BPF sweeps are all what the manual calls acceptable, but none of them are really centered on the bands in question. In fact all of them are centered below

TNX I will! Mike Krieger [email protected]> wrote:

With a little testing, I see that JS8call, with the radio mode set to "Data/Pkt", will use Digi mode on the QMX if you manually set QMX to digi mode.? It for some reason does not seem to ever send

C'mon in Mike, the waters fine!? ;-) 73, Robert, WA2T

No calibration is needed to listen to SSB. It isn't really needed to transmit SSB either. Better performance for TX if you calibrate. Tony AD0VC ________________________________ Sent: Friday, March

Do I need to do the calibration to listen to SSB and will CW and digital not be affected if I load the beta? I haven’t done anything about a mic yet but want to see how it sounds on RX without

And here's more info from Qrpguys that was apparently published before turning the mic design into a kit. Be sure to read the kit instruction manual (from the above page)

James, that's pretty typical, and mostly due to variances in component tolerances, toroid winding differences, your output transformer, etc. Nothing to be worried about. -- 73, Dan - W2DLC

This SSB update is fun to use! both on digital and SSB modes.... Thank you so much, Hans! But in the interest of finding bugs to smash...: I attempted to do Calibration from the front panel on the

Thank you gentlemen, I was able to send an email last night at level 6. What's the best way to set up for switching between Winlink/VARA and JS8 call? I noticed in JS8 call there's a radio setting

Thanks Brian . I am reluctant to try the SSB firmware. Mike Krieger [email protected]> wrote:

I am seeing this as well. Attempting to do calibration from the front panel hangs at 80m 1300 measurement. I wanted to run it from the front panel because I have tone spurs on some bands that go away

Congratulations and thanks to Hans! Conditions were good enough to make my first contacts today on my QMX on 20m. I built K6ARK's microphone (

Thanks for the quick feedback. Indeed the problem was me :) I discovered some not properly soldered joint and now everything works.

Yes, the same SMPS boards work on all revs of QMX and rev 1 of QMX+. [email protected]> wrote:

Hans loving the SSB, I've put together a tiny mic for it the audio seems really good, all your efforts were worth it . I would just say to anyone using the SSB firmware before you plug any type of mic