I updated the SSB beta testing webpage of the brave, here:??and released firmware version 1_01_003 to it. These are the changes:
Bug fix: Initial value for noise gate samples was 100 (should be max 99) - makes no real difference but it needed to be fixed
Added TX indication underlining the A character when transmitting from USB sound card in SSB mode. Note that the two possible states for this indication are a single dot (indicating PTT has been applied and now the radio is in TX mode) and the solid bar (indicating audio is being received from the PC and transmitted). There is no double-dot like there is in Digi mode indicating insufficient volume, because in SSB mode the radio transmits whatever you give it, even if the volume is low.?
Bug fix: CAT command TQ1; did not cause transmit when in SSB mode. Now TQ1; and TQ0; work properly in SSB mode.?
Bug fix: Prevent button presses from accidentally activating VOX, which was happening due to sound picked up from the internal (cancellation reference channel) microphone when you pressed buttons right next to it, and that prevented band change because the second click of the double click was ignored because by then the radio was in transmit mode. All fixed! Now you can click buttons however you like and when button clicks are done, VOX is temporarily disabled until your button pushing frenzy is over.?
Power meter now reads Peak Envelope Power (PEP) when in SSB mode. Previously it was just reading a sampled value (NOT an average); so if the power meter was updated 10x a second, the updates would just randomly pick a value from the SSB amplitude?envelope, which was most unlikely to be its peak value.?
Bug fixL Calibration hung at DAC 1300 when run on LCD. Now the calibration completes properly when run from the LCD.
Many thanks for all the feedback so far, SSB in QMX is getting better and better!
