Re: Front Push Button Switches

MVS Sarma All Messages By This Member #21394 One could use low watt iron like 10w. That is what i do,to prevent switch body loosening of the pins in those front panel screw fixing type . regards ?sarma ?vu3zmv Regards MVS Sarma ? toggle quoted message Show quoted text On Thu, Feb 8, 2018 at 7:56 PM, Tim and Janet <kb2mfs@...> wrote: This happened to me too.? I didn't think I applied too much heat but apparently I must have. Be quick and careful or like you mentioned use a heatsink. I luckily had one in my stock. 73, Tim KB2MFS On Feb 7, 2018 10:50 PM, "Ronald Berry" <wb3lhd@...> wrote: The front panel normally open push button switches will melt and fail if you apply to much heat. Replacements are available at Amazon and eBay for cheap. When soldering the connections I grabbed the connection with an alligator clip to heat sink it near the switch. This protects it from heat damage and all is fixed. Ron-WB3LHD

Join [email protected] to automatically receive all group messages.

开云体育