I managed to get it running, by deleting the message contents Hans. Now got it running with my transverter and output was originally not enough to drive the transverter, until i switch my hf rig off.....hi. Now got 10w out on transverter. Probably some earth loop cause and effect. Now I need to build a receive converter to fit inside the same box.
From: Hans Summers
To: QRPLabs@... Sent: Tuesday, 30 July 2013, 15:30 Subject: Re: [QRPLabs] error: message
?
Hi John?
To be clear:
I think you have put in your callsign, locator and power into the Message setting. This is not what is needed for WSPR!
You need:
1) "Mode" set to "WSPR"
2) Your callsign in the "Callsign" setting; or your callsign alone in the "Message" setting
3) Locator in the "Locator" setting
4) Power in the "Power" setting.
73 Hans G0UPL
On Tue, Jul 30, 2013 at 8:48 AM, John Randall <m0els@...> wrote:
?
No space in? callsign window M0ELS, but put spaces in the message window? M0ELS JO01 27
73 John
?
Digitally signed mail - M0ELS
From: Andy Cutland <gj7rwt@...> To:qrplabs@... Sent: Monday, 29 July 2013, 22:49 Subject: Re: [QRPLabs]
error: message
?
Hi John,
Are you including a space after your suffix. If you are then take it out.
73"s
De Andy
------------------------------
On Mon, Jul 29, 2013 12:59 PM PDT John Randall wrote:
>Trying to run the hardware in wspr mode, but keep getting error : message. Any ideas as it happens with no message or with one.
>
>CW mode brings up the clock >00 WHICH IS COUNTING DOWN i PRESUME TO TX MODE.
>
>
>73
>John
>
>?
>Digitally signed mail - M0ELS
