Re: Wire guage on LPF's ?
|
Yes Andy, that was my thinking as well.
?
What I have done on other boards is clear the hole with a piece of the
Enamelled Copper Wire with the end cut across at 45degrees, it seems good enough
to clear the excess solder and if you are too heavy handed (like I often am) the
wire will just bend before it does any damage (unlike a drill bit).
?
?
73, Colin M0XSD.
toggle quoted message
Show quoted text
Sent: Tuesday, June 4, 2013 11:34 AM
Subject: [QRPLabs] Re: Wire guage on LPF's ?
?
?
Hi Colin,
Yeah I got sway with it on one, but not the other. Just a
bit too
much plating in the whole to allow it to fit.
Using 0.5mm wire
is nicer though. It does allow quite a bit more
tensile strength to hold the
toroids in place.
73 de Andy
--- In mailto:QRPLabs%40yahoogroups.com,
"Colin XSD" wrote:
>
> Hi Andy,
>
>
If it is any help, I have managed to used 0.5mm Enamelled Copper Wire on an LPF,
it was a tight fit but not too tight once the Enamelling was cleared
off.
>
>
> 73, Colin M0XSD.
>
>
|
