Jeff,
I have no doubts at all about that last part. Anything not working here is on me and my relative noviceness! The kit is great and the instructions (mostly) very clear!
T501 And L502 make sense as starting points. Thank you. Just needed a thread to start pulling on.
Michael WD0OM
On Thu, Sep 26, 2024, at 05:45, Jeffrey W Moore via groups.io wrote:
Hi Michael,
?
that’s great that it is alive. ?Congratulations on that part.
?
look at all of your soldered joints under magnification and a bright light. ?Look especially at T501, the output transformer. ?If you didn’t scrape the enamel off the wire and solder those well it would exhibit this problem. ?The same for L502. ?Remember that the rig will work correctly if all parts are in the right place and soldered well. ?It’s rare that a part is defective.?
good luck
?
--
