开云体育

Simple is best, thanks.

I ordered mine from Pacific Seacraft in Washington, NC [email protected]> wrote:

Hi all, My plastic screen covers for the cockpit and deck scupper have broken down. ?Just need the circular screen insert but have yet to find them on any marine supply site on the internet. Anyone

Update: too much FLEX ?in ?1/2 inch starboard, went with 3/4 and seems much better! Daryl

Our group is rather on the small side: I funded the first few years, so we had FILES and PHOTO ALBUMS, etc. We lost that when we went back to the FREE program. I have several files you may be

I’ll check my manual tomorrow and send a copy of running rigging specs if Daryl doesn’t have it readily available as well. Best, Lisle <Lisle.kingery@...> wrote:

This website seems to have some info fwiw https://www.mauriprosailing.com/us/category/4-Pacific-Seacraft-31-Halyards.html Lisle [email protected]> wrote:

Hello Daryl and all, I own a small rigging company and have a client who has a PS31.? I was searching for a rigging spec sheet but haven't been able to dig one up.? Mainly, I'm looking for lengths

Yes, that is a consideration. Daryl

Hi Daryl, One thing to watch out for is to be sure you have enough room between the side of the new alternator casing and the port side of the engine “box”. It may not be an issue…but I don’t

Planning to install a Balmar 100 amp alternator on my Yanmar 3GM30F . Purchased the serpentine belt/pulley kit and the new alternator already has the right pulley! anyone done this before? Any

I have down graded the group from PREMIUM services to FREE version. Did not get enough interest in group funding: and thus discussion group is just not as active as it could be…. I will keep it

Yes, I think the best course is to change it to the free version; which eliminates files and photos, but no one seems to be taking advantage anyway. Daryl

Hi Daryl, Thanks for your Email. At this point I think there are not enough participants for this group, unlike the Dana 24 group I was a member of when I had a Dana 24. There was endless questions ,

This Discussion Group's current cost is $20.00 a month. I have been funding this myself since starting this site. GROUPS.IO now provides an easy sponsorship method: if you would like to contribute to

High density foam: I would touch base with Steve Brodie at the PSC factory - my first instinct would be no - due to compression; their pounds per meter is pretty low compared to density of marine

Thanks for the feedback. I am considering Coosa blue water 26 composite and epoxy. Any opinions on using Coosa to rebuild the mast step?

The mast step on Intuition, our 1990 Pacific Seacraft 31, was rebuily in 2017. There are 3 layers of fiberglass with marine plywood sandwitched between. The layer just beneath the deck layer of

Hello - I am in the middle of refurbishing an 88’ PSC31. This boat was a hurricane salvage so lots of projects ahead of us. Just finished up with topsides delamination project. Mast step moisture

? ?Thank you Vicky for your information. I think for all of us in this group it would be great to see pics of the davits and how it works/looks with the 31.(when they are installed) Albert