开云体育

Thanks, Scott, I'll take that as a "don't worry about it". -John

A few inches from a peacock would be considered “loud”. Thanks, -Scott Sent from a mobile device. Please excuse my brevity.

Stefano wrote "Unless you are recording loud things: [use] regular SP48.... As to what qualifies as "loud", if you're not sure if your sounds will be too loud, describe them and group members can

Hi C, the file you mentioned is the fruit of a tedious but interesting work, needed to verify some options we were discussing at that time, so no explanations, just measurements. I totally agree with

That's correct. I was making the point that all the mics have pretty similar responses. Note that even comparing the LF response only, the regular SP48 is only down less than 2dB at 30Hz... I don't

Hi Casey - I am talking about the low frequency response rather than the whole response - but my understanding is that the graphs on Page 4 refer to "V1" through "V5", which are all Simple P48. On

Make sure you are looking at the correct graph -- AFAIK the frequency responses are about equivalent in terms of flatness. Maybe you are confusing the low frequency section with the whole spectrum?

Hi all - I am looking at the message board file by Stefano Simonelli ( /g/MicBuilders/files/ss%20files/SimpleP48%20PUI%205024L%20HD%20FULL.pdf) and it seems that the "Modded 3-Wire"

Jules Ryckebusch: It would seem that pin3 to the capsule "+" is the right way to do it. Also the U87 you have is wired the same way according the test you have already done..... Still there are a

Most of the data sheets for electret capsule show them with the FET's source grounded and the output taken from the drain, which suggests that the electret diaphragm produces a negative pulse when

The following photos have been updated in the Scott Helmke ( /g/MicBuilders/album?id=186281 ) photo album of the [email protected] group. * FET topology.jpg (

Since I don't think I've seen it come up yet, here's the basic FET diagram relating to polarity. With a simple two-wire connection to an electret you're getting the inverted output (also that bottom

"Arjay, if you reverse the capsule connections in a normal “true” condenser mic, nothing happens there, either…….” "I hadn't realised that... I had always assumed that if you reverse the

I recorded a couple handclaps and snap sounds with the SimpleP48 wired with pin3 to the capsule "+" and this is the resulting waveform. [image: Screenshot 2023-12-26 at 7.56.53?AM.png] [image:

thanks again all for the links and suggestions @adrian- yes I buy from Nick at micbooster all the time, v helpful and excellent service

Sorry to contradict you on some points. You cannot compare directly a standard externally polarized capsule with an electret capsule. First because the former is parallel-fed, while the latter is

I buy my cables at Thomann. Mostly "Summer Cable" or Mogami from ebay. Am Mo., 25. Dez. 2023 um 10:26 Uhr schrieb Ralf R Radermacher via groups.io <fotoralf@...>:

Am 25.12.23 um 09:16 schrieb underwood via groups.io: They're fine. Just stay away from their cheap cables. Two strands of wire aren't a sufficient screening and I've had the connectors literally fall

For as far as i know, and you said it already, the electrons are trapped in the electret, so it is impossible for them to move. So you cannot measure anything. Not by a multimeter or something like

Conrad is very expensive. I buy most of my stuff at Reichelt Elektronik. They sometimes have PUI-Audio capsules in stock. Am So., 24. Dez. 2023 um 17:39 Uhr schrieb ilya dontsov <