开云体育

Will try to share some tests next Friday or Saturday. Regards! HL

*Why do you need RD1 and RD2, wouldn't be one RD enough? Same for RS.* Resistor values for RD and RS need to be very specific, depending on IDSS, VP JFET values, and input voltage. Two resistors are

Any recording tests you could share?

Yes. Only resistances are a source of brownian noise. Reactances are not. This is where it takes some discussion. I take it as a 3.2uF capacitor, that has a reactance of 1Kohm at 50Hz. Its

Unless there is a need for a high pass filter, using a larger coupling cap won't hurt. Something that's often forgotten is the series reactance of a cap is a noise source, just like a series

Understood. That last explanation about Bipolar was really refreshing from the old days, thanks! Why people don't use? 10uf? 63V, or even 10uf 100V? Is it only for the space it takes physically

An aluminum electrolytic capacitor consists of two Al foil electrodes separated by a conductive electrolyte. Al forms an oxide coating on the surface on contact with air or water, and the oxide

We are probably worrying about nothing TBH. Jules @ Sound Sleuth designs excellent circuits, if he says it's good, it'll likely be good. I can only see a problem if you're intending on capturing low

The other issue is size of the capacitor. I’m the 3.3uF 63V guy. They work great and physically allow you to build the SimpleP48 into the XLR connector. I use this with my ZoomF6. Best

Thanks for the explanation Michael, the point about tolerance is really good. My plan is to connect that Mic's via XLR to a new Zoom F3, but better for a capacitor rated for at least 50V like this

I've used both polar and bipolar in the signal lines in microphones. It doesn't make much difference so long as the capacitor value is sufficiently high to pass the low frequencies. A bipolar

Hi all! After a lot of reading, I see for short cables (less than 2 meters) the Simple P48 circuit is enough for a good quality build. My question here is: I see a lot of people talk about taking

Fig-8.doc in my FILES directory describes a Fig-8 capsule I designed some 40+ yrs ago for Calrec.? It has sources for 5 & 10 um Aluminised Mylar and other useful info.

Excellent result -- well done! :) I must confess I didn't think I was going to hear something quite that impressive, when I first downloaded your mp3.... If one could create a version with a

Excellent!!!! More microphone Instructables! Best Regards, Jules Ryckebusch

Full Instructable now available here: https://www.instructables.com/DIY-Large-Diaphragm-True-Condenser-Microphone-Caps/

Very interesting!

** Search for: V-PROTECH Premium FOIL Thermal Emergency Blanket ** For the UK: https://www.amazon.co.uk/V-PROTECH-Premium-Emergency-Survival-150x100cm/dp/B09TRZT5T1 I deliberately went for the

alloy foil from old wax capacitors as diaphragm. have used in home made ribbon mics. ________________________________ Sent: Wednesday, 13 April 2022 8:33 AM To: [email protected]

where do you get this sheet? I bet not all space blankets are the same and this thin.