开云体育

Ok, I tried with acceleration of 1. I'm working with mm so it is 1sec for 1mm/sec. It is VERY slow. The problem persists. This is what happens: The 1st axis accelerates as it should. When the 2nd axis

Isak: . You need to decrease your acceleration to about 1 or less to do this test. Does the axis slow down to stop, then backlash correct, then accelerate again? I'm just trying to figure out if the

Isak: Let me check to see whats what. I'll get back to you... Art www.artofcnc.ca

I've set the acceleration to 10 (which is rather small). Then I issued a "G2 x0y0 i10 j0 f300" command from a x0y0 position. It was very obvious that there is a sharp stop at each 90 deg. There was no

Hi Art; Are the G61 & G64 commands working? On my machine they don't seem to be working but setting constant velocity on state page does. Would it be possible to have a indicator led that would show

Derek: On mine, all three axis do the verify. Can you double check the status of the home LED's on the diags page, does all look normal? Art www.artofcnc.ca

Steve: What are the Normal and current SpinCounts doing and what does the netrance trigger say.. The Normal and current Spin Counts are the number of interrupt period between pulses from your index.

time, so I yes i do

Derek: Do you have switches on all 3? I haven't used verify for some time, so I will do a check. Thanks, Art www.artofcnc.ca

Steve: Ouch, that sucks. But your desciption is very helpfull. I'll look in the code to see what can cause this and let you know what I find. I like the description of the adder, it will probably lead

Bob: Very soon an OEM macro will be created as well as seom more system specific macro's. They are next on my list so hopefully by next version. Thanks, Art www.artofcnc.ca

Daniel: Sorry for the problem, can you send me the actual file, sometimes its a strange problem with the comments themselves. Send me the file and I'll check it out right away. Thanks, Art

Hi Isak: Can you descibe this better. Is CV mode turned off, does the unit stop at each 90 degree boundry of the circle? Have you tried setting acceleration very low to see the effect better? Art

Thanks Jeff: I'll let you know what I find.... Art www.artofcnc.ca

Hi Art When I click on verify only the z axis moves. X and Y remain stationary but give out a count. Derek

Art, It needs the Zero individual axis and Zero All buttons on the jog screen. It does not need them on the MDI screen. For me the normal use on a machine without home switches is to jog to the

Hi Art - bit of a disaster testing threading. Program runs 10 increments, on first it pauses for ages - looking at thread diags, spind adder climbs into the millions, then goes negative and spindle

Hi Art; Have you given any more thought to being able to execute a OEM code from a macro call? Thanks Bob Harvey

Luis, Try the Fanuc post. If you have a problem, I should be able to create a special post. Bob Campbell

<mehmetgogus@d...> wrote: run not Hi Mehmet, Try OverRide Limits at Corrections page. Rgrds, Daniel.