开云体育

Jerry: I do intend to handle this with a Taper Wizard. I am preparing the code for easy use and addition of Wizards to do these types of tasks. For the Taper, an Angle or Taper number will be

I see from my rapidly overflowing mailbox that some of you have an email virus. I have letters from several with "Approved" or "You details attached.". I suspect a bad new virus is on the

Good idea a "virtual compound rest" to work with a jog button....You would need to type in line like: G0 Z4.0 X.5 then there should be a code for jog...if you don't want it executed. (if the taper is

Hi Servo I started up in vga mode and the problem went away. unfortunatly I only had 640x480 res and that aint gonna cut it with mach2. I tried uninstaling the video card drivers and reinstaling but

Hi Art/Group....In the process of altering the video setup from 32bit to 256 colour (this by the way has reduced the "shot bearings" sound on Mach1, I'll try MachII next week) however I now have a

Don't know what Video card you have but I had similar problems on my Compaq laptop with a ATI Radeon 7500. Switching to 1024x768 or 1280x1024 resolution (from the native LCD 1440x1050) and disabling

Hi Art and others I noticed that during the execution of a move, if you toggle between screens the pulse output is interrupted. On my machine if your going more than thirty inches a minute and

Hi Art 'n All, First let me appologize for posting to the former forum, I really must delete that icon rifght away! I've been reading some "International Correspondence School" books that my Dad

Derek, The symptoms sound much like my PC acts when I have Mach2 and the Internet opened at the same time. I'm running an Intel P4 3.06gHz CPU and even with that Mach2 still demands the undivided

Hi Arturo I'm at home on an XP machine. I'm running windows 2000 on the problem machine but I don't think it has that option. I'll check it out when I get to work in the morning. derek

Servo: I may attach them to macro calls so they can be immplemented by me or someone else as need arises. Art www.artofcnc.ca

Art, Do you have any plans for adding spline interpolation (G06)and hypothetical axis interpolation (G07) to Mach2? Servo

Art: Good point, hadn't thought of that one....Might even work.. Art www.artofcnc.ca

Jerry: Thats what I tend to call the "Futz" factor. Its when you run 100's of tests and convice yourself that a problem is connected to a certain function or event. Only to find that co-incidence

Hi Art, That being the case, my problem with a certain code running in the wrong direction may have been an intermittant bad wiring connection, although it seems that the results were very consistant

Well its getting weird If I bring up the task manager and open up Mach 2 the CPU usage hangs around 15 percent. When I load the Gcode the usage jumps up to 100 percent and becomes sluggish. If I

Jerry, Only when the direction changes. The direction line will stay in whatever state it is in until a different state is set. Bob Campbell

Jerry: The Direction pin holds its level until it needs to change to another direction. This is to make it conform to most controllers specs. . Art www.artofcnc.ca

Hi All, Can someone tell me if a direction pulse is sent to the servo controller, (Gecko), for every step, or only when the direction changes? Thanks Jerry

When I started to get swarf in my Keyboard I went to CompUSA and picked up one of those flexible, waterproof keyboards. The keys are sealed between sheets of molded rubber. You can pour a coke or a