开云体育

i talked to tech people at whiteside. southeast and vortex. it would be great if i could use a larger cutter but this is basically not possible after really trying to figure out how. i could buy 5/16"

i had "finish" cuts and got rid of them. this helped.

<spencer@...> wrote: Check the place you're ordering from - - - they might offer some parameters.

You can't really do light cuts in wood (like a 'spring cut' in metal) because it'll splinter etc, maybe that's what was happening so the deeper cut from the higher feed rate helps with that. You

I need help with my cnc router set up. I screwed up some out put settings on an older mogul router. On Tuesday, May 11, 2021, 11:09:30 PM CDT, spencer@...

holder could be more rigid but not without a lot of work basically redoing the whole 4th axis. i did get it tighter increasing the pressure on the air vise and using a sandpaper strip to help hold the

it did put an icon on the desktop but mine is so full of crap i missed it and not knowing what it was called i did not find it in the start menu. i installed it on my router and since the desktop is

The installer should have asked if you wanted an icon on the desktop. If not I guess you should look in the windows start menu. ron ginger

<spencer@...> wrote:

Hiya Dale: If you CNC the 13x40, the first thing to go should be the compound. Make up a solid mount to hold your toolpost at the right height and you will have more rigidity. Echoing another

I had the same concern a few years back when I converted a 10x20 lathe to CNC. I almost added hand wheels on the steppers but was talked out of it. Rights I have been using the MDI functions on Mach4

So I built up a Little Machine Shops minilathe with Mach4 and PoKeys57 ala the Techshops design put together by Joe Katona and Ron Ginger. Works pretty good for small stuff. Minlathe needs physical

I am getting really tired of making the same parts i have been making for 7 years. the only fun is making improvements. So I decided to work on my gcode and clean it up and optimize tool motion. gets

I installed the wizards and the process seemed to complete but nothing shows up in the recently added programs list and i can not find the newly installed programs anywhere? Any hints? -- Best

They are a separate program you cannot call them from Mach. But you can transfer the gcode directly into mach. We made them a separate program so they could be used with other controllers- even

my version is old, i will check out the new one. -- Best regards, Spencer Chase 67550 Bell Springs Rd. Garberville, CA 95542 Postal service only. Laytonville, CA 95454 UPS

Not sure how you think CamBam is old the last release was march 2020 but an update is being worked on. simple in cambam load in your old project and just change cutter size and re produce gcode.

i installed the wizards, where do i access them?

i have a license and expected the wizards to show up in the wizard tab, did not know i needed to download them. will try that.

I am speaking about the Mach4 wizards. They can be downloadd from the Mach site, machsupport.com. They run in demo mode without a license, you can use it all and create job file, but you cannot save