开云体育

Which model control unit do you have? Does your system also use a PCI card installed in one of the accessories slot? Dan Mauch

Hello all, it is strange no one commented on my issue. Logosol seem to be US-made products. I thought you guys should be familiar with them. Thanks

Having a little trouble connecting a German MPG encoder to Mach3 all the button presses are recognised on the mach screen but no run up/down movement when I rotate dial. I don't have any motors

Unfortunately, the ferrite on the USB cable most probably won't improve it by much. V V sob., 22. feb. 2020 ob 07:09 je oseba spencer@... < spencer@...> napisala:

will spend more time with this tomorrow. the intermittent stuff is annoying but at this point is not the biggest concern. the USB cable is built into the device so i have no choice of quality re

Hi, Spencer The latest version of the PoKeys software is always available for download from https://www.poscope.com/downloads/. The setup package contains PoKeys configuration software and Mach3

I can't actually help you, I'm afraid. Stuff like this is why I keep trying versions of Linux. So far, it has the same sorts of problems. Maybe not quite so bad. But also a fairly steep learning curve

pokeys is supposed to just work. i doubt that compatibility would help. i followed all online suggestions about net 3.5 or whatever and that had already been selected. i found info on firmware update

If the computer isn't talking to the board, or whatever the thing is on the right pins, at the right data rates, and logic levels, polarities, and clock speed, you won't ever get it working. Sometimes

i can try that the next time i boot mach3 but the problem seems to be related to the pokeys plugin very specifically. hard to imagine it will make much difference. Best regards, Spencer Chase 67550

Have you set the compatibility mode for the software you're trying to run? That MAY help. Or not, but it's worth a try if you haven't already done it.? I've not had to do it recently, since I'm still

My router is working perfectly with an old Dell Optiplex PMDX122 on onboard parallel port. I wanted to get a new little solid state computer working that does not have parallel port. I have a Pokeys

oops... yes both on old Dell Optiplex (775 or so) ptegler

DITTO. My Smithy and my custom CNC router table are both on M3 under XP. not a flaw yest in ops in 5+ years now ptegler -- Paul Tegler ptegler@... www.teglerizer.com

I have had a really good experience with Dell Optiplex (old and cheap) single processor PCs. I have 2 that currently run Mach 3 under Windows XP flawlessly. Follow the setup recommendations for

Thanks everyone for your feedback - very helpful!

looks like another way to do it. i have a B dro added to my screen and add one to B each time the sub runs to make a part. seems to do what i need. Best regards, Spencer Chase 67550 Bell Springs

Spencer, I use counters in my Mach3 program and have attached some jpg's of the macros and Mach3 modified screen. I am using only the X & Z axis. It is actually a lathe running mach3 mill. The main

I have been using Dell Optiplex computers for my mill for a while. I bought about 10 spares all the same and cloned the hard drive so I hopefully can just swap one computer for another if the onei am

Hi Brian, Eventually all old PCs die. :( There are a number of options available and everyone will have different opinions so you may need to sort though them. This is mine. To get rid of the