开云体育

Hi JohnThere is nothing worse than a machine that you can't trust.? I feel your frustration.?I have an ethernet Smooth Stepper that has done 14 hour jobs and never missed a beat.Running on

And mine is this one: https://www.pmdx.com/PMDX-126 For all I know this is causing a problem during homng. E-Stop, Fault, ERR/RST, and "Charge Pump" timeouts turn off all outputs without assistance

Hi Dave, I have a PMDX-126 which is optically isolated for inputs and the control outputs. The Step/Dir are not under the assumption that most drives are. In my case they are. The problem has

Hi SpencerNo.? Some are straight though...https://www.cnc4you.co.uk/Breakout-board-BM01?search=Break%20out%20boardBut read the spec on this

I have been following this thread but not carefully because I didn't think I had a problem. Now I am thinking that some minor drift I have over time could be missed steps not mechanical as I

I've posted my solution to electrical noise on this forum a few times and no one has come back and said it did or didn't work for them, but when I had random missed steps? and spent a long time

Just tried that. And the problem with working on these types of issues is what I just ran into. I set it to 10x40uS. Quit. Restarted MACH3 and homed over a 4" distance. No problem. Perfect.

have you tried the debounce input setting in general config? had a similar issue long time ago and debounce cured it. don't remember what I had to set it at but it worked. haven't used Mach3 for quite

In mach3 config> general Config in the top right corner have you tried to increase the debounce time. If not do not increase it too much or you willoverugn the limit switches. But also your plan to

I went into the config page and checked the 5kHz charge pump. The only repeatable failure I'm getting on a regular basis is when I home the Z axis. Here's what happens: 1. Ref All Home

Years ago there was an issue with the charge pump frequency not associated with? a laser. It was many years ago but you might try to do a search in the archives about charge pump freq. I vaguely

What will that do? Easy to try but I'm curious what you expect to see happen. Thanks for the feedback. John Sent: January-28-20 9:20 AM To: [email protected] Subject: Re: [MachCNC] Electrical

Sometimes making a problem worse provides the solution to the issue at hand. In Mach3 go to config>general config and on the right side clcik on the box for 5KHz for laser. See if that provides any

Hi Martin, Peter, I'll check. Status on this part of the project is that all appears to be working even if not exactly the way I'd like. I still have to cycle the ENABLE button on the MACH3 display

Worked like a charm.? Thanks

will try that password.? Thanks for the recommendation

Try “Mach1Pass” without the quotes.

When I try to configure my Mach3 software, I get a configuration locked message.? I did not lock my configuration and do not have a password to unlock it.? What do I do now?

The green light only indicates that you have 5V from the USB hub to the uc100. The LED on the other side is a blue LED that is on when the UC100 is initiated and starts up from Mach 3. If you don't

I had this happen as well. I went into config and unchecked the box on UC100 and rechecked and all was back to normal. Sent from Mail for Windows 10 Sent: Sunday, January 19, 2020 8:58 PM To: