开云体育

Both require 2000 or XP, Master5 runs under 98. -- Steve Blackmore

Hi Caudlet thanks again for your comments I plan to mount the encoder on end of the ballscrew,not on the motor shaft. Yes, it is a 10mm pitch screw,40mm dia, I have a few servos to pick

Tom I am including a DXF file of the modified drawing. Jim

Carl, Dont forget that motor maximum speed is at zero torque (no load), maximum power is at half that, so you will need to take the load into account when doing the calculations. Bernard motor

I'm a registered user of Mach1 and I'm now onto Mach2. I'm in the process of completing my second mill a 1985 south bend knee mill 10 x 54 with ball screws on all 3 axis for my home shop. running

Hi, just wondering which post works best from Mastercam9 to Mach2? I have read that MPFAN.pst works but are any changes needed? Anyone using this? Thanks Dean

<snip> the program operation, fill in the mach2 and run and covert program? Not a user but I followed this up and while there are problems registering to access their site this link was sent me

I'm a KipWare user. You will have some difficulty when it comes to cutting radiuses or circles. They only true post is a "Faunc compatable" and it doesn't produce either an I or J for a radius cut.

Just for point of reference. I printed it out on my HP 970 series printer. Printed both sides. Then went to local Kinko's and they bound it clear front cover, solid color back cover, and wire

Hi This may look like deja'vu as I just posted this on CAD CAM. I know this is a big request. I'm getting ready to rewire my control and have posted a wiring diagram in the files section called

Hi- Is the a way to execute simple lines of g-code from a macro ( mo3, g01 etc. )? If so what is the proper way to enter this info into a macro. Thanks Todd

Hi Todd, I was wondering this also, at least can I call a function or similar also, I think its a subset of VB scripting and can call some predefined( not user defined (?)) routines Art has setup.

good day all, I'm going to update my controller/motherboard and was wondering if an AMD Duron 1.47 ghz processor and 512 megs of ram will be potent enough to run mach 1/2 ? i have always used

Hi Jeff, I have been running all the mach software, including the latest version on a PII 233 with 128mb ram and win 2000, it works perfectly. Last week I got a chance to buy 5, HP Duron 1300mhz at

Is anybody running the latest version of Mach2 with spindle speed controlled by step/dir? If you are - does it work as expected?? If you are running an earlier version, please let me know which

jeff, I've got one AMD computer that works and one that doesn't. Its not the processor... its something in the chipset. The one that doesn't work is a gigabyte. The one that does is a spacewalkker

Steve Blackmore <steve@p...> wrote: Steve, I'm in the process of changing over to M2 and have just checked the spindle Step / Dir circuit. Using a 100Mhz 'scope I can see that a lot of pulses are

The problem I have, is although they are being generated the steps out are reverting to some arbitrary value. Although Mach2 seems now to be storing the value, what it puts out isn't what I set. I can

I have in my possesion a KB electronic model KBMM-225D controller, and the opportunity to get a treadmill PM motor(90-130Vdc@...... full load amperage??)its pretty close to be rated within the

<indigo_red@q...> wrote: similar manual to <snip> I agree it's murky! Documenting macros seemed a bit like writing the user manual for a Swiss Army Knife! It would be very helpful if you and