--- In mach1mach2cnc@..., dholness@a... wrote:
I'm a registered user of Mach1 and I'm now onto Mach2.
<snip>
I'm now trying to configure a post in KipwareM program from
www.kentechinc.com
to match mach1/2. I've made a few basic runs nothing fancy with
the program
seem real easy to used. just select the type of machine
operation, fill in the
blanks and out comes the code. Then I just load the file into
mach2 and run
the part.
The software even has a dxf converter that will take the drawing
and covert
to G code.
Just would like to know if anyone else on the list is using this
program?
Not a user but I followed this up and while there are problems
registering to access their site this link was sent me which gives
access to somw slide-shows of thir software.
KipwareT supports turning.
Best wishes
John Prentice
