I just downloaded Mach2Mill and tried to configure it. The manual
says I should have about 24,600 Hz. My Puse Frequency starts high
but goes down to 1100-1200 Hz., the program will keep running (very
slowly) until the screen saver kicks in. Then when I hit a key to
return to the regular screen the P/Freq will go up to 25,500 Hz for
about 15 sec and then drop dramatically low again. I cannot
maintain
a consistant Pulse Freq. over about 1300 Hz.
I am running M2M Release 1.90 on a Compaq 2.6GHz, 512 Mb. So far I
checked to make sure Quicktime (Qtask.exe) is not installed, made
sure LAN is set to 100Mbps, disabled the screensaver, cleaned the
system with SpyBot, and started with a clean boot. So far nothing
works.
Thanks in advance for any help. The Program is just what I want,
but
don't know if it will work on my computer. Bill B
