Ok thanks Art I will send you the file.
Tim
--- In mach1mach2cnc@..., art <fenerty@a...> wrote:
Hi Tim:
Can be a lot of reasons for that one. I take it your in CV
mode, enhanced
pulsing is selected?
Send me the code if you like, Ill see if its coarse as a
generated file..
Thanks,
Art
www.artofcnc.ca
Videos And Support Forums
Users Map:
----- Original Message -----
From: "vertcnc" <petersen_t@s...>
To: <mach1mach2cnc@...>
Sent: Wednesday, January 25, 2006 11:58 PM
Subject: [mach1mach2cnc] Constant velocity smoothness problem.
I have a 3d file of basicly a 2 1/2" dia dome.I can't get the
feedrate
hardly above 5ipm. When I increase the feedrate higher, the
motion is
very rough. My configuration is .200 pitch on the ball screws
with the
encoders mounted directly to the ends of these ball screws. I
have
Mach 3 set at 10,000 steps per rev. Normally motion is very
smooth
until a get into 3d moves then seems thinks get rough.
Any help would be appreciated. I could post the file if needed.
Thanks
Tim
www.machsupport.com - Web site Access
Yahoo! Groups Links
