开云体育

Single Messages Topics Expanded Polls

Re: pokeys almost working

Steve Stallings All Messages By This Member #154096 The PoKeys CNCDB25 under Mach3 or Mach4 (and the PMDX-411 under Mach4) only support 4 pulse engines/axes. As best I can tell, the UCC100 does support 6 axes. Regards, Steve Stallings www.PMDX.com toggle quoted message Show quoted text From: "spencer@..." <spencer@...> Sent: Mon, 24 Feb 2020 10:17:43 -0800 (PST) To: [email protected] Subject: Re: [MachCNC] pokeys almost working the B axis is enabled. i have tried every possible choice for ports and pins although i am sure this does nothing if the machine is using the pokeys.?? i just did another sanity check. when i went to ports and pins B was not active even though I had selected it before so i thought ????? well after selecting it again, it still does not work. I used the MDI and it works for X Y Z and A but not B. In the config utility for Pokeys there is no B axis that can be configured or at least I can not find anything. i reset the motion control device selection at startup in fcn config so it asks each time i start mach3?? if i choose no device i can change the B axix in the MDI?? if i choose Pokeys, I can't. i think this really suggests that it is a Pokeys issue. ?? ?? Best regards, Spencer Chase 67550 Bell Springs Rd. Garberville, CA 95542 Postal service only. Laytonville, CA 95454 UPS only. Spencer@... Spencer@... Spencer@... (425) 791-0309 (707) 223-8212 ------ Original Message ------ From: "Andy Wander" <ohawiseguyeh@...> To: [email protected] Sent: 2/24/2020 9:46:01 AM Subject: Re: [MachCNC] pokeys almost working G-code moves shouldn?€?t depend on what motion controller you are using. ?? Telling Mach to move the B axis by ?€?1?€? should move it whether you have a parallel port, pokeys, Smoothstepper, etc. ?? Is it possible that you have not enabled the B axis in your new setup? ?? If you use the MDI to command ?? G91 G0 B1 G90 ?? Does the DRO change? If not, you need to look deeper than the pokeys, at the rest of your setup. ?? From: [email protected] <[email protected]> On Behalf Of spencer@... Sent: Monday, February 24, 2020 12:31 PM To: [email protected] Subject: Re: [MachCNC] pokeys almost working ?? that is exactly what i have in my gcode and it worked perfectly with the parrallel port and mach3. i don't think it even mattered what pins or ports i had assigned to the B axis. the "moves" changed the B axis DRO. Now with the Pokeys I can not find any way of getting the B axis DRO to increment. ?? ?? ?? Best regards, Spencer Chase 67550 Bell Springs Rd. Garberville, CA 95542 Postal service only. Laytonville, CA 95454 UPS only. Spencer@... Spencer@... Spencer@... (425) 791-0309 (707) 223-8212 ?? ------ Original Message ------ From: "Ralph Tuttle" <ralph.tuttle@...> To: [email protected] Sent: 2/24/2020 7:24:27 AM Subject: Re: [MachCNC] pokeys almost working ?? Spencer, Perhaps a macro or sub G91 ;enter incremental mode b1?? ??; move/increment B by one G90 ;enter absolute mode TIA RT ----

View All 12 Messages

#154096

Join [email protected] to automatically receive all group messages.