开云体育

Single Messages Topics Expanded Polls

Re: pokeys almost working

[email protected] #154095 the B axis is enabled. i have tried every possible choice for ports and pins although i am sure this does nothing if the machine is using the pokeys.? i just did another sanity check. when i went to ports and pins B was not active even though I had selected it before so i thought ???? well after selecting it again, it still does not work. I used the MDI and it works for X Y Z and A but not B. In the config utility for Pokeys there is no B axis that can be configured or at least I can not find anything. i reset the motion control device selection at startup in fcn config so it asks each time i start mach3? if i choose no device i can change the B axix in the MDI? if i choose Pokeys, I can't. i think this really suggests that it is a Pokeys issue. ? ? Best regards, Spencer Chase 67550 Bell Springs Rd. Garberville, CA 95542 Postal service only. Laytonville, CA 95454 UPS only. Spencer@... Spencer@... Spencer@... (425) 791-0309 (707) 223-8212 toggle quoted message Show quoted text ------ Original Message ------ From: "Andy Wander" <ohawiseguyeh@...> To: [email protected] Sent: 2/24/2020 9:46:01 AM Subject: Re: [MachCNC] pokeys almost working G-code moves shouldn’t depend on what motion controller you are using. ? Telling Mach to move the B axis by “1” should move it whether you have a parallel port, pokeys, Smoothstepper, etc. ? Is it possible that you have not enabled the B axis in your new setup? ? If you use the MDI to command ? G91 G0 B1 G90 ? Does the DRO change? If not, you need to look deeper than the pokeys, at the rest of your setup. ? From: [email protected] <[email protected]> On Behalf Of spencer@... Sent: Monday, February 24, 2020 12:31 PM To: [email protected] Subject: Re: [MachCNC] pokeys almost working ? that is exactly what i have in my gcode and it worked perfectly with the parrallel port and mach3. i don't think it even mattered what pins or ports i had assigned to the B axis. the "moves" changed the B axis DRO. Now with the Pokeys I can not find any way of getting the B axis DRO to increment. ? ? ? Best regards, Spencer Chase 67550 Bell Springs Rd. Garberville, CA 95542 Postal service only. Laytonville, CA 95454 UPS only. Spencer@... Spencer@... Spencer@... (425) 791-0309 (707) 223-8212 ? ------ Original Message ------ From: "Ralph Tuttle" <ralph.tuttle@...> To: [email protected] Sent: 2/24/2020 7:24:27 AM Subject: Re: [MachCNC] pokeys almost working ? Spencer, Perhaps a macro or sub G91 ;enter incremental mode b1? ?; move/increment B by one G90 ;enter absolute mode TIA RT

View All 12 Messages

#154095

Join [email protected] to automatically receive all group messages.