Hello, there is nothing complex I think. The machine uses home, limit switches, tool length switch, tool clamp, maybe analog spindle speed control. Nothing that MACH cannot control already.
As I see I can put some Smooth stepper in place of the original PCI/ motion controller and use the original power supply with the drives running at step/dir mode. That is not as bad as I thought in the first place. The RS-485 links will be unused.
toggle quoted message
Show quoted text
On 23 Feb 2020, at 1:18, Dan Mauch <dmauch@...> wrote:
?On Sat, Feb 22, 2020 at 11:33 AM, Todor Boshnakov wrote:
w quoted text
That's a pretty complex system. I do see that the servo amps can take step and direction signals but then the massive other features would be difficult to get around. I don't think Mach3 can deliver all the features of your current system.
|
Dan mauch
?
On Sat, Feb 22, 2020 at 8:41 PM Dan Mauch < dmauch@...> wrote: Which model control unit do you have? Does your system also use a PCI card installed in one of the accessories slot?
Dan Mauch
?
?
|
From: Dan Mauch <dmauch@...>
?
?
|
Are you sure you wish to delete this message from the message archives of
[email protected]?
This cannot be undone.
Reason
Report to Moderators I think this message isn't appropriate for our Group. The Group moderators are responsible for maintaining their community and can address these issues. Report to 开云体育 Support I think this violates the Terms of Service. This includes: harm to minors, violence or threats, harassment or privacy invasion, impersonation or misrepresentation, fraud or phishing.
?
Note: Your email is included with the abuse report.
?
The new topic will begin with this message. Subject of the new topic:
?
