开云体育

Hi Steve, Bridgecom sells an MMDVM upgrade for their repeaters that looks to be based on the same Repeaterbuilder MMDVM board I have been experimenting with. I can't confirm M17 runs on it, *yet* but

I support your idea, Steve. Voice repeaters are silent.... Data is the way to go. Adopting would be much easier if direwolf software could be used as a TNC for M17 Packet mode. I already opened an

I think that upgrading (or creating from scratch) a wide-area repeater to do “just another digital voice mode” (especially one that has only a few radio options available) will be a challenging

A primary reason that I consider M17 now viable is that it’s possible to build a repeater for use by M17. I first realized that from this mention of building an MMDVM repeater, which was capable of

I just discovered this… https://m17.club/ The premier M17 Amateur Radio Club Where the M17 Project is largely centered around development of the protocol and implementations of it, the M17

Hi. I’m Chip, W0CHP. I’m a M17 Project developer/sysadmin and board member, and I’m also the founder/principal author-developer/BDFL of the WPSD Project ( https://wpsd.radio ). Ben, KU0HN, is

Hello, This is Ben KU0HN. As far as M17 hardware I have: 1 MMDVM RPi hat hotspot running WPSD 2 MMDVM Pi hat modems.? These are both a work-in-progress.? One will be connected to a Kenwood

Austria is fine as well…

Hey, if it comes down to it, we can order a bunch and send them to Austria. *ahem* I mean Australia. --- Steve KC1AWV M17 Project

Hi! LW7EMN, Juan, from Azul, Argentina. It is nice to see some community build-up Thanks for the zero retries moderator! I had been experimenting with M17 for a year.

I hope these get off the ground.? Unfortunately, exchange rate makes them rather expensive here, but if I get a windfall, I'll add one to my list of (future) devices. -- 73 de Tony

As I said in my intro post, I have the following M17 hardware: Gateway: MMDVM (both hotspot and modem with external radios). Client/user: MMDVM with M17Client and 9600 capable radio. Module1 with

I cheated with the cable, as I said, because I knew the Module17 was pin compatible with the BI7JTA and Repeater Builders MMDVM boards, for which I had a cable on hand.? You can order just the cable

New to M17 with no M17 specific hardware yet. Still in the observing and learning mode. Steve N5QC

CSI has a pre-release announcement for two M17 HT radios and are accepting orders. https://www.csi-radios.com/radios/connect-systems/ I have no affiliation with CSI, but I hope these radios "fly off

Hi, this is Werner OE1WRS. I have only M17 RX capability with SDR++ and Airspy. Can someone post details on the proposed / in development solution for replacing UT-1xx DSTAR boards with a M17 capable

Than you all for joining this list! I hoped for maybe a dozen of us and we’re comfortably past that. I’ll be at least another day before I can actively participate here as we visited our daughter

Thank you, Tony, for the description of your efforts for M17. I've been circling M17 RF for over a year and am on the threshold now with a Lilygo M17 module 0.1e and a cable that's almost ready for

Hi everyone, just a quick introduction. Tony, VK3JED here, located in central Victoria, Australia. I've been following the M17 Project since late 2020, when I discovered it by accident via one of

I am big on configuration or setup sheets to document my working (and often failed) configuration(s). They often become good templates for other users to start from. Steve