开云体育

I'm hoping that someone can help with this problem. I'm control a Losmandy G11 using ACSOM driver for Gemini II. The picture shows of the problem. I've researched this but to no avail. NINA shows the

Very wise counsel from W Maxwell. ?The most difficult part about buying new gear is understanding what you own expectations are vs. your budget. ?Once you get that worked out, the rest falls into

The following photos have been updated in the JMD G11T ( /g/Losmandy_users/album?id=254767 ) album of the [email protected] group. * alnitak calibrated master stack.jpeg (

Peter good point. That’s corrosion and oxide growths the potting stopped this formation. ?The socket needed replacement (bugger of a job but can be done ) . It looks to be moisture causing this

I received the GM811G over the summer and my instructions indicated that the RA and DEC motors ARE IDENTICAL (both are SVM-HTS); mine is the basic system;? and it does not matter which motor goes

Thanks all, yes I did reset the worm gears indoors a while ago, it wasn't too cold outside last night but it was very heavy with condensation, everything was dripping wet, tried it today indoors with

Never had balance make the backlash too small on my GM8 Gemini 1 OR v1.05 mounts. That just means the backlash was set incorrectly for the temperature. Set the backlash on a cold mount and the issues

Yes, that was that. I tightened them and it is now solid. Thank you. ________________________________ Sent: Saturday, November 28, 2020 6:24 PM To: [email protected] <[email protected]>

Thanks, Brian. We should have clear skies tomorrow night, so I can give it a go. Matt

Hello David, Ian posted this problem on SGL as I'd had a similar issue with my Gemini1 some years ago I posted a reply. After having the issue for a period of time it dawned on me that it was moisture

Yeah but this time setting up indoors there is no load. ?Incorrect balance load can cause huge headaches. Balance is everything. Especially with the older motors. ? Experienced users balance it one

When in doubt, do a cold start. and if that's in doubt, do a reset to HGM defaults Brian

Dunno where I’d get the switch membrane … a replacement HC is $270 I’d like to get a case back as his is broken do you know the make of the case? D. Sent: 29 November 2020 00:31 To:

Did you adjust the worm clearance lately – if so, and you did it inside the house, then when the mount cools down it will bind. You need to adjust when cold or allow a degree of “slop” when warm

Brian, Thanks for the link. I haven't done a cold start since putting in the new battery. Matt

It's worth using the tool at gemini-2 to confirm your settings (in a format you can use for Gemini II) https://gemini-2.com/lat_long_from_address.html Can you elaborate on what's happening - you

No sure what to say.....is there loose screws?? Under the cap? -- Brendan

Magnus, It is roughly an hour. I haven't tried to get a more accurate estimate, but I think that's pretty close. That correlation with DST is why I looked at the time in the handset :( Matt

I’d say clearly there was an issue. ?Maybe swap the HC front membrane and top case. Not much else to say. Apart from try recreate the OPs user conditions. I still feel it’s moisture! -- Brendan

Yes. It’s not idea; but yes you can. wrote: Brian Brian Valente portfolio brianvalentephotography.com <http://brianvalentephotography.com>