开云体育

rigctl --version rigctl Hamlib 4.3 Wed Sep 01 02:14:39 2021 +0000 SHA=5a6134

yes used Build-a-pi -- Loyd C. Headrick WX4LH <http://wx4lh.com>

Which version of hamlib are you running? If unsure, run this command: *rigctl --version* -- 73, de KM4ACK YouTube ( https://youtube.com/km4ack ) | Tip Jar ( https://www.paypal.me/km4ack ) Twitter (

Worked great, thank you.

Did you use Build a Pi to install the hotspot? -- 73, de KM4ACK YouTube ( https://youtube.com/km4ack ) | Tip Jar ( https://www.paypal.me/km4ack ) Twitter ( https://twitter.com/km4ack ) | Store (

All patches had been applied.

It looks like you didn't select a patch to apply. Highlight the patch you would like to apply and then click "apply patch" -- 73, de KM4ACK YouTube ( https://youtube.com/km4ack ) | Tip Jar (

I ran into this very issue yesterday. My issue was I had filters turned on. Verify that you don't have any filters engaged that might interfere with incoming packets. -- 73, de KM4ACK YouTube (

Hey everyone... So, I've been trying to play a little bit with getting my IC-705 to work with Direwolf & Xastir. In addition to Jason's vids, I've also found this site helpful:

Unit hostapd.service could not be found get this when i run this sudo /usr/bin/autohotspotN

Hi Jason, Running The Update tool and invoking the Patch Tool ends in an endless loop at the end of the Update Tool beginning with the following window: The work around I am using is to "X" out of the

I'm not sure about the TS-2000 DB-9 port; but using the FT-847 I have needs using a NULL-modem ( reverse TX /RX < pin #2 and #3 on a DB-9 > you might check the pinout on the TS-2000 ..... just a FYI

Cross posting to see if anyone has any input. ---------- Forwarded message --------- From: James French <w8iss1@...> Date: Sun, Sep 12, 2021, 11:55 Subject: Sub RS-232 adapters and Kenwood

My Pi3B stopped seeing the gps even after a clean rebuild of the entire system.? I found the fix in this video: https://youtu.be/YIIC-iT6H-s ( https://youtu.be/YIIC-iT6H-s ) When I reinstalled GPSD

When I first built the Pi4B with BAP 3.08, the frequency would populate into the Pat window box but a red line would appear through the box with an error message indicating a failure to communicate

Patch now available :-) I also created an issue ticket so this can be addressed in a future version of BAP. https://github.com/km4ack/pi-build/issues/301 -- 73, de KM4ACK YouTube (

I tried to enable wifi thru raspi-config say could not see the adapter, then open the wpa_supplicant.conf? file removed the entries for the hot spot. rebooted was restored

Rig control staying red in Conky indicates that it isn't running. If it isn't running, Pat will not be able to control the rig. If you run into the same thing on the new system, let me know. I

Hi Jason it does put the freq in the block and with a line through it but then in the black screen it also say it cant connect which i assume is via ip to the flrig package Also rigcontrol on conkey

It will throw a wrench into things if everything isn't connected. Direwolf expects a sound card to be connected when it starts. Double check me but it looks like the Signalink supports your radio.