开云体育

I believe you are talking about the Winlink Gateway. If so, check out this section of the Winlink Gateway video. https://youtu.be/F_s4zIUIfew for setting it up. The information should update on the

Hey Anthony, You might try posting this to the FLDIGI forum. Avid users hang out there and might be able to give you some suggestions. It's been a while since I have used FLAMP but it's on my to do

HI Kevin Format of drive is Fat32 I believe and it has worked in the past. This is not the first time I have had this problem with this drive. I am not sure if it is the drive or what. I think I will

Thanks Tom, Got it going.

No, it wasn't lighting up. I'll give that a try and report back. Thanks! Beau W6ERR

How is the drive formatted? Does it show in a terminal window and run: df -h Usually you can safely unmount a drive using in a terminal window: sudo umount /dev/sda1? # and sda2 and however many

Hi I have had a problem a few times. I may get cleared up if I reload the OS onto the mico SD drive, I use Buster yet. What happens is that when inserting my PNY 16GB drive I use to save files I want

I found the script "getardoplist" in /home/pi/patmenu2. Inside it says: #Two versions of this script exist. One for manual downloads and #one for cron downloads. The one for cron has no YAD interface.

Where should I look in the file system for the outbox location? I did find archive, in, out, sent in this path... ./home/pi/.local/share/pat/mailbox/K4GMV so I then searched the entire system to see

I would say hop on Toads discord and talk to Joseph. 73 N5SKT [email protected]> wrote:

Thanks for the picture! Now this is even more intriguing. Moonbounce with that little yagi? and low power.I have got to learn more. Jim

In Jason's previous message, we reset the config file to defaults, then updated the call sign, password and grid square, so I don't think it's a problem with the config file. Hope everything is ok

I'm glad I could fix your Telnet issue! Not sure about your other one. I'm on the way to the hospital again now and I think Jason is going to be out of commission for a few days so it might be a bit

Rich/Jason, tnx for guidance. I made the changes in Jason's video but somehow I must have been fiddling and the entries were all changed. I made video changes and all is well again. -- Tom VE3NY

I have my grid square defined in the config.json file. I've updated it manually and by GPS in Pat Menu. Conky is showing my grid square and the "Find Gateways" script sees my grid square,. But when

Oh, Joseph built the Yagi shown and I think that is an Icom 7100. Best Regards, Don -- Best Regards, Don - N5SKT

[image: image.png] To be clear, this is Joseph's success. Joseph's call is VE3GKT. 73 de N5SKT [email protected]> wrote: -- Best Regards, Don - N5SKT

Tell us more! What is your system? Antenna and software? Someday I would like to have success with my 9700 but not able to decode anything yet.Jim KI6WJ I

[image: image.png] -- Best Regards, Don - N5SKT

Yikes!!! You know Jason's recent video about spending hours going round-and-round in circles, looking for something complicated, while ignoring the simple mistake? Yep... I was selecting telnet under