开云体育

Hey OM David; While I cannot DIRECTLY answer that question, I can clearly state that starting out Headless and Wireless (from the Get-Go) does allow you to convert back and forth from headless to

I'm still learning Groups.io and spent a little time looking, but can't find the answer to this question: When I setup my Pi4, I had it connected to monitor, keyboard, and mouse. Now I want to convert

Has anyone dealt with a rigblaster nomic and direwolf it wanting to keep the rig keyed up -- Sent from Yahoo Email App for Android

Jason, I am setting up with both a local screen and remote via VNC using a couple of different iPads. ?I was wondering if you have a strategy for changing the screen size to fit the different remote

It is a one inch hole. It is privacy window screen fabric. (It is not metal) It is secured with a little hot glue. ?At the fire station for my 24 hour shift, will snap some pictures of the inside

That was my original thought, and I even have some leftover black fiberglass window screen....I wish I would have done that instead hihi

Are you able to start conky from the ham radio category of the pi menu? If not, open the terminal and run *conky*. Post any error messages you see. Also, run *bash ~/pi-build/diagnostic* and follow

Stan, That looks really well executed. Is that window screen mesh painted black? Would you mind posting a photograph of the inside so we can see how you secured the mesh? That looks like about a

Nice video Bob. Very thoughtful. I looked at many 'single level' cases -- but when you need to incorporate a HAT, the choices are limited -- particularly for robust cases made from metal (Mazack,

Thanks, Mitch, I have two of them and so far all is well. ?I still need to adjust the fans a bit to optimize them. ?I have had no video issues. One of these will be used in the field and the other

That's right purtty, good work! ________________________________ Sent: Friday, August 21, 2020 10:02:22 AM To: [email protected] <[email protected]> Subject: Re: [KM4ACK-Pi] Case Options

Excellent video, Bob. I hope you have had greater luck with your Argon One case than I have! I ordered one direct from Argon40 back on 01 June as there wasn't any available on Amazon at the time. It

Bruce, all, I have been testing the Argon One Pi4 case from Argon40. ?It does not accommodate a HAT It runs all of the cables out the rear. ?I got the case on Amazon US for $25. I am fussing with

Hi David I think the plan for the laser cut lid? is for them to make one (when the laser guy is back from hols on 1st September)? I will then do some tests to compare with my own hacked version and

I just drilled one hole and used some mesh behind it to keep stuff out of it. ?It made a noticeable difference in temp.

Hi Jason The reboot killed CONKY. It didn't come back up! 73 Bruce G4ABX

Thanks for that report, Bruce. For those here in the US, I think the same buck converter is this one: https://amzn.to/31jdzlc — I’m saving it in case the DockerPi doesn’t work out. That lovely

A reboot should clear up the conky issue. There was a change in the way conky is started in 3.0.3 but I don't think that should cause a freeze. -- 73, de KM4ACK YouTube ( https://youtube.com/km4ack )

All I'm using the Pi Juice HAT and this case: https://thepihut.com/products/anidees-extra-tall-raspberry-pi-4-case?variant=31037505503294 The case is very well made -- but a tad expensive! it has one

Morning all BAP 3.03 has been up for circa 20 hours. No repeat of my Wifi issues. CONKY 'froze' after 11h 14m 43s. The Pi is still showing the correct time but CONKY is not I'm not sure if this is