开云体育

Don, What was the it you modified?? I'd like to try it but I'm just new to the Pi, but I'm having fun. Thanks, Tim

This is what I get.? Any suggestions? I also don't get gps info in conky.? I'm using the recommended GPS and it locks (flashing green). Any suggestions? Great piece of work here, Thanks!?

I hav searched far and wide, but can't find the answer to this question: What if I want to swap between GPS devices, but don't want to update the code each time? Would it look like

First verify the port of your gps witht the following command. ls /dev/*USB* You should see your gps as /dev/ttyUSB0 Now edit gpsd sudo nano /etc/default/gpsd Change your Devices to the

All, There is a bug in 3.0.2 that can keep chirp from updating. A huge thanks to Jerry for allowing me remote access to his system today. If you are having an issue with Chirp updating, open the

Roger, that's beyond what I am doing with it.

Im not having a problem with it logging from wst-x or fldigi. The problem is when using phone ops and ae using dxspots running, cqrlog will not talk to flrig to change frequency’s when clicking on a

What exactly are you trying to make it do? Or rather, what is it not doing that you think it should be doing? I have my CQRLOG reading data from FLDIGI and WSJT-X software on the logging command.

I and trying to get flrig to work with cqrlog and not having any luck. I have every outer program on the BAP working great. Thank you for all the hard work Jason and every one else this BAP is a

Allan You need to have VOX to PTT unless you use Cat to PTT the radio. I have use Hand Helds to Mobiles. HT and some mobiles have VOX., (Looked to see if FT8900 has vox. Didn't see anything) I use

Spend a few hours at the Smokey Mountain Knife Works, it has something for everyone. 73 Keith?KY4KS?

Hi All, First, let me say that this is a great forum and I would not have been able to set up my Pi4 without the information contain herein! Conky on my pi4 w/4gb and the latest build (installed

Don, Thanks for the reply.? There is no VOX in EasyDigi. Alan K6ZY

Jason, Does BAP rely on VOX to key a transmitter (at least in VHF FM)?? The configuration menu(s) have a section for PTT.? Does this send a signal to the USB port to key the transmitter?? If so,

Thanks for the reply Jason. I have the software installed and should have my gos dongle tomorrow. I figured that was why it showed an error where the grid square normally would’ve be on

Alan, From a quick search, it doesn't look like that rig is supported by FLRIG or rigctl. You may have to go with a sound card like the Signalink that has a VOX circuit built in that can key the rig.

Hey Bryan, This page https://tiny.cc/km4ack-faq ( https://tiny.cc/km4ack-faq ) has some help for 7300 owners. Scroll down to the section that reads "Can you help with radio X". There's a great How To

Is there VOX. As far as I know there's no vox in Easy Digi keyer Don va7dgp wrote:

I have set up Build-a-Pi and am trying to use it to do VHF Winlink.? However, I can't get it to key my FT-1500 xcvr via the data port.? I think the FT-8900 would be the same as they have the same

No, it does not. That’s the problem. James KA9VIG