I just went through this, the BAP script did not work so I followed the directions in and all is good.

Rich

KQ9L

___________________________
Think different, Macintosh.

?

This e-mail, and any attachments thereto, is intended only for use by the addressee(s) named herein and may contain legally privileged and/or confidential information. If you are not the intended recipient of this e-mail (or the person responsible for delivering this document to the intended recipient), you are hereby notified that any dissemination, distribution, printing or copying of this e-mail, and any attachments thereto, is strictly prohibited. If you have received this e-mail in error, please respond to the individual sending the message and permanently delete the original and any copy of any e-mail and any printout thereof.

On Wednesday, December 8, 2021, 12:38:22 PM CST, David via groups.io <sv0sgs@...> wrote:

I did a fresh installaton of Bullseye on a brand new out of the box P4b with a brand new rtc.? The BAP installed without any apparent error message.? I wasn't around the whole time the installation was proceeding.? GPS and all the chosen applications were installed. I still have to check that they all work.? I did see that RTC was not installed.? When I used the BAP update tool to re-install I got the error message that the i2c interface needed to be activated.? Well, it was activated.? I checked.? Just to be sure, I de-activated it, rebooted an activated it again.? Installing RTC I still got the same error message.? I did check RTC module using the command sudo i2cdetect -y 1.? It returned the expected "68."? I also tried different RTC modules, but got the same negative results.