开云体育

Ours do not behave this way. We regularly test with the UXB cable attach, but monitor the JackAl audio out. Did you cut the trace on the bottom of the Teensy? Jack, W8TEE

All: Two JackAl owners have reported that a voltage spike destroyed their RA8875 display. Al has looked into this and found that there is a very narrow voltage window on the display. Buydisplay

Jack, JAckAlV095 Another bug that you are probably already aware of but thought I would pass it by you.? Discovered it while using the debug monitor. With the USB connected to the computer the JackAl

The values actually end up being written to EEPROM so they will be available the next time you start the program. Jack, W8TEE

Some success tonight. was able to get the calibration routine running !! yea !! run through the sets about 20 times...got very close values across each 10.. now I'm not too sure where those values go

Definitely this has been SOLD

Wow that was fast, I believe this has been spoken for, pending funds. Jim, W0EB

I am finding that I simply do not have the time to tie things up long enough to complete this project so I'm offering what I have (see picture) for sale. JackAl board from QRP Guys, Teensy 3.6 with

I'm almost done with my Version 5 ?BITX. I need to modify the volume control shaft for the knob I want to use and I want to add a small fan for the PA's. Al's looks better as he has more patience

on the way dave k7da

I purchased a number of 680 nF 1206 inductors for L5 and L7 to address the uBitx spurs for version 4 pcb (the fix also requires correct relays not included). I have lots of spares of the Inductors.

We have our V5 test boards all working now and it did not require any changes to the hardware. We will be posting a new version of the JackAl code "soon", but I want to make a few more tests before we

Was able to compile JackAl 0.95. Installed Arduino 1.8.9 to it's own directory (did not use installer, downloaded ZIP) Installed Teensyduino 1.4.6 beta 10 (available on their forums) Removed RA8875

I like this idea. because if it is way out of calibration there is no way to get to Setup and then select from the menu. n2aie vince

Uggg.. Still no headway.? Guess I'm not understanding where to put AL's 7 inch values.. maybe I'll try a bit more tomorrow. bummed Vince n2aie

Al and I are working on a new draft of the manual, since we had to build a couple of new rigs to test V5 of the uBITX. In the meantime, take your time and follow the manual, as what you need is

Look through the messages, as I sent this today: #ifdef AL7 // ------------------------? Al's 7" Calibration ------------? 8-14-18 ? calty = map(yFinal, 838, 174, 50, 430);?????? // Al ?

jack my apologies.? this 76 yr old mind is not firing on all the cylinders anymore. i was sitting here awhile ago and duh why did i ask that question. and i did find the two schematics that have the

The software is the JackAl software that is downloaded from the hamradiodesigns.com web site. As to the voltages, we assume that the rig is powered by 12V-13.8V from a suitable power supply. If you

Perhaps code in the ability to utilize an unsual HMI condition, such as holding an encoder switch on, while booting up to bring up an initial display size selection screen. ?Use encoder to select