开云体育

I just received my JackAl board, and am wondering if anyone has extra parts they'd be willing to sell. IDC connectors, SMA connectors, pretty much everything that's on the Bill of Materials. I have

Thanks Jack, for starting the group. I have the JackAl, Teensy, audio board and the 5" display is on order. Looking forward to get started with the build. Bob -wb6kwt

I ordered the TFT display from buydisplay.com.? When I ordered, the Font Chip was not indicated.? Will I need to reorder the display or is the font chip required or may it be added?? I did send

All: You do not need the Font Chip. We use the fonts from the library. We included it on the purchase because it was an inexpensive addon and someone might want to experiment with it. Jack, W8TEE

I would encourage this, too, as large quantities often make a significant difference in the price. I hope this site becomes a clearing house for surplus parts, too. Jack, W8TEE

Still lacking a few items for my build but, I have identified the enclosure it will be using.? Hammond Metal Enclosure, 1456 Series, Sloped Console, Instrument, Aluminium, 106.83 mm, 356.11 mm Part

A sloped front is not a bad choice with any touch screen project, especially a ?BITX since it has such low mass. If you choose a square case, think about placing the rig on one of those

Hi something along the lines I need but I am going to be putting in a small valve audio amp as I prefer the sound . Just got work out what room is needed for fitting and airflow. But awaiting the

Super fast delivery via Her Majesty's Royal Mail of my JackAl board.? It arrived today.? Other bits and pieces gradually drifting in from USA, China and Oz. So cool! -- 73 Kevin VK3DAP / ZL2DAP

D'oh - QRPGuys is in sunny California not UK.? Need to swing the beam around. -- 73 Kevin VK3DAP / ZL2DAP

I usually make mockups of cabinets from foam board that you can get from most office supply chains.? Easy to cut out openings and it even comes in colors! I have a milling table set up on my drill

Dennis, How will you cut out the square opening for the display?? And mount the display in the opening? Hope you will post some photos of the "during" and "after". Thanks, Chuck WB6GPO

Good to see a new group, dedicated to this topic, where all "JackAlytes" can share information! Probably over time the work done here will spill over to non-Bitx platforms. Chuck WB6GPO

Apparently it snowed in the UK and is very cold prefer the weather in sunny California, but I have seen ice in San Francisco and snow on the hills! Barry Mayson

I will rough out the opening (the viewable area of the display) with a cutoff wheel in the Dremel tool and file to final size.? I print the panel layout on white, self adhesive label material stick

Al and I are looking forward to seeing it! Jack, W8TEE

Hello from France, I received JackAl this morning and I’m very happy. Just one question about bag of parts : where I can purchase these parts ? Vy’ 73s de Jacques – F1APY

Bonsoir Jacques: Alas, these must be purchased "on your own". If we had them fabricated on the board, it would have more than tripled the cost of the board. It's actually cheaper to buy them

------------ *JackAlytes* ------------ ROTFLMAO Will we have official robes, votive candles?and a doxology?

I share posts and comments that I find intellectually challenging, those that follow my perceptions, are information worth sharing and ones like this that simply make me laugh so hard that I