开云体育

All for sale 225 + 10.50 shipping contact N2AIE@...

The latest I have is attached. I'll check with Al tomorrow to see if there is a later one. Also, don't forget that the JackAl board has all the SMD parts mounted on it. Jack, W8TEE

I was reading through the BOM (page 25 ) and the schematic page 31 (jackal assemblymanual (ver16)-section 2 .docx), the component numbers on the BOM do not match, is there an updated version that

Thanks Rick.? I actually came across that last night as I was looking for info on Q101-102.? Looks like I am OK there. Vince N1VIN

Vince, I just reviewed the schematics again and I was mistaken about the hum without the teensy and audio shield in place. The signal goes from the recieve audio amp, Q101-Q102 to the input of the

Thanks Rick.? I shall check that out.? If Q101 and Q102 seem to work OK I will try a new Teensy. Thanks, Vince N1VIN

Vince, I doubt that much would need to be repaired on the JackAl board if any. Looking at the schematics the 5V only feeds the teensy board and the receive amplifier section Q101, Q102, but really

Good afternoon, I think I may have fried my JackAl PCB. -Connected only programmed Teensy 3.6,? 5" touchscreen and 12 volt DC supply -JackAl screen came up and all looked good -Then after about 60s

I did a simple scan of your website.? It claims your Wordpress version is out of date.? You will want to make sure you have the latest versions. looks like you have some redirection hack.? here is

Every time we attempt to fix the site, it's hacked again, so we've pretty much given up for now. Most of the JackAl files can be access through the group: JackAl groups.io Group | | | | | |

Today, 07/23/2019 I can't access the hamradiodesigns.com website as Nod32/ESet shows it as Threat found This web page contains potentially dangerous content. Threat: HTML/ScrInject.B trojan Access

Thanks a lot Jack. The instructions you have written are pretty clear, so hopefully I can reproduce your success when I finally get time to work on this (presuming the JackAl board doesn't turn into

No. His cables were wired incorrectly, to the point where he blew a BITX board. Al gave him a V3 extra board we had here so he could continue on, but each time we fixed something, it failed on his

Is this a common problem with the JackAl?? I have all the parts, the 7" display, and Vince's display protection board, but haven't had time to assemble it yet. -- Chuck WB6GPO

Officially throwing in the towel on this one. Gone through several expensive 5 inch displays and even had one of the designers add a protection board to yet another new display. The display (or the

James: QRPGuys.com is the only place we have authorized to sell the JackAl boards. From their first page: We ship product via First Class U.S.P.S., once a week, domestic and international to all

Hello! Are there any other places to acquire the JackAl board than QRPGuys? I’ve placed an order for 2 boards with QRPGuys on 7/2, received a tracking number on 7/12, but it's still stuck

Thank you Jack.? Having gone through all the documentation I have one more question.? Can you tell me precisely where the red wires goes in below pic from assembly manual?? It looks like the inside

If you wire up the connector, it has "guides" on it that will only mate with the ?BITX connector the right way. The schematic also shows the connections. Jack, W8TEE

That came out great Jack, very professional. John